Haier HL42S, HL40B owner manual Setting Up Your Remote Control, Code Display Mode

Operation

Setting Up Your Remote Control

SELECT

CH.LIST FAV.LIST AUDIOLIST

PIP SWAP AUDIO SWAP POSITION

	P.MODE	S.MODE
CC			FREEZE
	E	N	PUT
	TIM
	U		IN
N			F
			O
E

	OK
E					E	P
X				E
IT			L
		S
A	RC	P
		SA

Code Display Mode

1 Press and release SELECT button to desired device.

2 Press and hold OK button, then press SELECT button about 3 seconds till LED is on. Release 2 keys. LED flashes with the speed of twice per second.

3 Enter [9][8][0] in turn to enter Code Display Mode . LED is off.

4 Press and release [1] once, LED will flash. The times LED flashes is the first digit of code number.(no flash = 0)

5 Press and release [2] once, LED will flash. The times LED flashes is the second digit of code number. (no flash = 0)

6 Press and release [3] once, LED will flash. The times LED flashes is the third digit of code number. (no flash = 0)

7 Code Display process is end and exit the mode automatically.

8 Under Code Display Mode, the remote controller will be no reaction to other buttons pressed, and will automatically exit the mode if no any key is pressed within 10 seconds.

VOL+ CH+

VOL - CH-

Q.VIEW

36 TFT-LCD TV