Troubleshooting

For the sake of time and cost, it is strongly recommended that you check out the problem by yourself according to the instructions listed hereunder before contacting the after-sales service for technical assistance.

Problem			Possible remedies
No picture, no sound			Turn on the power supply;
			Properly plug the TV set to the power socket;
			Check to see if the power cable of other appliance is plugged in the
			TV set. Make sure that the power cable of the TV set is properly
			connected.
Good picture, no sound			Depress the volume button;
			Check out the audio frequency input signals.
Failure	of	remote	Check to see if the remote controller and plasma display receiving
controller			window are blocked by other objects and if batteries are properly
			loaded.

No color, weak color or			Designate the item of color from the Picture menu and depress the
poor picture			volume button;
			Keep the display and VCR separate a reasonable space;
			Activate some functions to store picture brightness;
			Make sure that the display and signal source are available and
			turned on.
Excessive	brightness or		Adjust brightness or contrast.
darkness
Picture too big or small			Adjust the setup of sizes.

One speaker failure			Balance the sound in the menu.
Slight sound from display			It is a normal phenomenon.

Note: Do not leave the television with static picture in an extended period as it may result in residual image on your television screen.

Note: Production of the plasma screen requires high and precision technologies. However, there might be some dark or bright (red, blue or green) spots, or some anomalistic stripes or spots. This is not defect. If the TV set is used in an area 2,400 meters above the sea level where the air pressure is below 750hpa, the picture on the plasma screen may be affected and a muffled sound might be produced. These phenomena might happen in the area 1,500 meters above the sea level. This is resulted from difference between air pressures inside and outside the display. This is not a defect covered by the limited warranty.

NOTE

Design and specifications are subject to change without notice.

The dimension in this manual is a approximation.