Haier HP32R owner manual Troubleshooting, Make adjustments by Fine Tune and Manual Scan

Troubleshooting

Troubleshooting

For the sake of time and cost, it is strongly recommended that you check out the problem by yourself according to the instructions listed hereunder before contacting the after-sales service for technical assistance.

	Verify if the television is properly plugged.
No picture, no sound	Verify if the television is properly supplied power.
	Verify if electricity is available.
	Verify if correct signals are input.
Blank screen	Press INPUT button to change signal input to TV input.
	Restart the television of power supply is interrupted.
	Press Mute button and verify if Mute mode is set.
No sound	Switch to other channel and verify if the same problem
	happens.
	Press VOL+ button to see if the problem can be solved.
Poor sound	Verify if sound system is correct. Refer to Page 22 for
	adjustments.
No picture in some	Verify if correct channel is selected.
	Adjust the antenna.
channel
	Make adjustments by Fine Tune and Manual Scan.
No color for some	Verify if the same problem exists in other channels.
	Check out of picture and sound systems.
channel program
	Refer to relative instructions in the Manual for color
(black and white)
	adjust.
Spots with some or	Verify if the antenna is correctly connected.
	Verify if the antenna is in good condition.
all pictures
	Make fine adjustment of channel.
Horizontal/vertical bars	Check for local interference such as an electrical
or picture shaking	appliance or power tool.
	Disconnect the television from power supply and, 10
Television out of control	seconds later, connect the television to the power supply.
	If the problem still exists, contact authorized after-sales
	service for technical assistance.

Note: Do not leave the television with static picture in an extended period as the image may become permanently burned.

Note: Production of the PLASMA screen requires high and precision technologies. However, there might be some dark or bright (red, blue or green) spots, or some anomalistic stripes or spots. This is not defect. If the TV set is used in an area 2,400 meters above the sea level where the air pressure is below 750hpa, the picture on the PLASMA screen may be affected and a muffled sound might be produced. These phenomena might happen in the area 1,500 meters above the sea level. This is resulted from difference between air pressures inside and outside the display. This is not a defect covered by the limited warranty.

40 PLASMA TV