QUICK INSTALLATION
When you turn on your television set for the first time, be sure to place it on a solid stable surface. To avoid danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.
| 2 | 3/8" |
|
2 | 3/8" | 7 | 7/8" |
Turning On the Unit for the first time
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on the screen to complete basic TV settings.
Make sure the RF aerial has been connected properly to the TV antenna input jack on the rear of the system.
1. Press the / button to select Yes. Press the | 2. Use the | / |
| button to select Antenna, then | ||||||||||||
ENTER button to proceed with the initial setup. | press the |
| / button to select Air or CATV. | |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3.Use the 
/ 
button to select Auto Scan, then press the 
button to enter auto scan menu. Use the 
/ 
button to select Start to Scan, press the 
button to begin scanning. (If you selected CATV on Step 2, you need to select Cable System before Start to Scan). The system will automatically start to scan and preset all available TV channels.
4.After scanning has finished the system will return to the first TV channel scanned.
E - 4
1/10/2008 10:04:26 AM |