Curtis RLED3218A manual Introduction, Front View

Page 7
Introduction

Introduction

Introduction

1. Front View

1. Front ViewManual backgroundINPUT MENU CH+ CH- VOL+ VOL- POWERManual backgroundManual background

Led Indicator

Remote Control window (Keep clear)

1). (IR) Infrared Receiver: Receives IR signals from the remote control. (Power on/Standby)LED Indicator: Press POWER to turn on and off.

Indicator on(Red)

Standby mode

Indicator on(Green)

Power on mode

The effective receiving range for the signal is 5-8 metres from the front of the remote control window, and 300 to the left or right side and 200 above or below the remote control window.

2). The functions of the buttons:

INPUT: Press to display the input source menu. Manual background

MENU: Press to display the OSD menu, press again to exit the menu.

CH+/-:Press to scan through channels.

VOL+/-:Press to adjust the volume.

POWER: Turn on/standby the TV set.

TV

AV

Component

HDMI1

HDMI2

HDMI3

VGA

Press INPUT button on the TV set or remote control to display the input source menu, and use CH+/- button on the TV set or Manual background/ Manual background button on remote control to select the input source, press OK button on the remote control to enter.

Note: Before you select the input source, make sure the connections are prepared.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents MODEL RLED3218A 32” LED TelevisionPage Simple Troubleshooting ContentsSafety Information Unit and AccessoriesCorrect disposal of this Product Safety Information Safety InformationElectrical safety Physical safety 1 2 4 5 7 8 Unit and AccessoriesUnit and Accessories Instructions for fixing standIntroduction Introduction1. Front View 2. Rear View IntroductionDo not mount your RCA TV at more than a 15 degree tilt This RCA TV is compatible with a 200mm x 100mm mounting hole pattern1 2 4 5 7 4. Remote ControlInstalling Batteries Basic Operation Power on/offInput Source select Basic OSD Menu operationDescription OSD MenuOSD Menu 1. Picture menu2. Audio menu 3. Time menu Closed Caption 4. Setup menuTV Use Note Do not forget the password5. Lock menu CanadaAir/Cable Allow you to select antenna between Air and Cable 6. Channel menuAuto Scan Enter the Auto Scan menu to start auto scan Show/Hide Allow you to show or hide the channels TV does not respond to remote control Simple TroubleshootingSimple Troubleshooting No powerTechnical Specifications VGA FORMAT MODE PRESET MODE FOR VGA HDMIResolution ResolutionHow to get service LIMITED PRODUCT WARRANTY RCA CANADA TVEXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, THIS WARRANTY What your warranty covers
Top Page Image Contents