Using the 3D Glasses
Disposal of the 3D glasses (Excluding Australia)
Remove the 3D glasses battery, and then follow these steps to take the 3D glasses apart.
1Pull out the nose pad with your fingers.
2Remove the five screws with a Phillips screwdriver (commercially available).
3Pull the front casing outward with your fingers
while pulling the base of the right temple arm inward with your fingers (
s
).
4Cut off the three cables of the rechargeable battery unit one by one with a pair of scissors.
•There is the rechargeable battery unit inside 2 on the right temple arm shown below.
•Insulate the tip of the removed rechargeable battery cable with material such as scotch tape.
1Right temple arm
2Rechargeable battery unit
3Rear casing
5Pull out the entire rechargeable battery unit and remove it from the rear casing.
NOTE
• Used batteries should be disposed in accordance with local laws and regulations.
1Front casing
2Base
3Right temple arm