Technika DVDFAW08 manual Getting Started, Connecting to the TV

DVD Player DVDFAW08

GETTING STARTED

Connecting to the TV

The Quick Start Guide shows how to connect your DVD player to your television. These methods are described below.

SCART lead

The SCART lead (not supplied) should be used to connect your DVD player to your TV. This connection uses component video signals i.e. the red, green and blue (RGB) content of the video are sent as separate signals. This gives an excellent quality video signal.

RCA AV cable

The RCA AV Cable (not supplied) can be used to connect your DVD player to an external sound system such as your home stereo or a surround sound system. This connection method separates the left and right audio signals to provide superior quality sound.

The Remote Control

Installing the Remote Control Batteries

1. To remove the battery compartment cover, push the cover away from the remote control.

2.Place two AAA size batteries in the compartment following the battery polarity (+ and -) symbols

indicated inside the battery compartment.

3. Replace the lid in position and press until it clicks shut.

Use of the Remote Control

To use the remote control, point it at the right hand front of the DVD player.

The remote control has a range of up to 6 metres from the DVD player and at an angle of up to + 30 and -30 degrees.

Do not block the path of the beam from the remote control to the DVD player.

NOTE: Sunlight or very bright light will reduce the remote control sensitivity.