Some Digital Terrestrial channels operate on a Pay Per View basis. These require a subscription and a hardware decoder.
Obtain the Conditional Access Module (CAM) and the viewing card by subscribing to a pay channel company, then insert those to the TV using the following procedure.
•Switch off the TV and unplug from the mains.
•Insert the CAM and then the viewing card to the slot that is located in the terminal cover at the
•The CAM should be correctly inserted, it is impossible to insert fully if reversed. The CAM or the TV terminal may be damaged if the CAM is forcefully inserted.
•Connect the TV to the mains supply, switch on and then wait for few moments until the card is activated.
•Some CAMs may require the following set up. Please set the CAM by entering the IDTV menu, Conditional Access then pressing the OK button. (CAM set up menu is not displayed when it is not required.)
•To see the viewing contract information: enter IDTV; press the “MENU” button, then highlight Conditional Access and press the OK button.
•When no module is inserted, “No Conditional Access module detected” message appears on the screen.
•Refer to the module instruction manual for details of the settings.
NOTE: Insert or remove the CI module only when the TV is switched off or in standby mode.
TV Setup
You can use this item to display the TV functions.
The digital TV Setup menu screen is accessed from the main menu. Press the “MENU” button to display the main menu and use “
” or “
” button to highlight “TV Setup”, press the OK button to display TV Setup menu screen.
You can find detailed information for all menu items in “Analogue TV Menu System” section.
Setup
The adjustments in this menu are given as the following:
Configuration
You can configure the settings of your TV. Select Configuration from Setup menu and press OK to view this menu. Press the EXIT button on the remote control to exit.
AC3 Audio (* for EU countries only)
In the Configuration Menu, highlight the AC3 Audio item by pressing “
” or “
” buttons. Use the “
” or “
” buttons to set the AC3 Audio as On or Off.
If the channel that you are watching supports AC3 Audio, turn this setting on.
Hard of Hearing (* for EU countries only)
Use “
” or “
” button to select Hard of Hearing and then press “
” or “
” button to set this setting as On or Off.
If the broadcaster enables any special signal concerning the audio, you can set this setting as On to receive such signals.
Favourite Mode
Use this function to enable or disable favourite mode. Press “
” / “
” button to set this function as on or off.
English - 15 -
_50153024.indd 15 | 16.08.2009 11:42:32 |