Basic adjustment
Manually tuning channels
General
Manual tune
You can manually tune new services after the first time installation has been completed.
Manual Tune |
|
| |
UHF Channel | 42 |
| |
Frequency (kHz) | 641787 |
| |
Bandwidth | 8MHz |
| |
System |
| DVBT |
|
Mode | 2K | Guard | 1/32 |
FEC | 3/4 | Mod | QAM16 |
NID | ==== | TSID | ==== |
Systems Found / Added | == / == | ||
Tuner Lock |
| Lock | |
Signal Strength |
| 19% | |
Signal Quality |
| 40% | |
OK Watch | Exit | Exit Menu | Start Scan |
You can manually tune new services after the first time installation has been completed.
1Press c/d to select the desired UHF channel.
2Press b to select ‘Frequency (kHz).
3Press c/d to adjust the frequency.
4Press b to select ‘Bandwidth’.
5Press c/d to adjust the ‘bandwidth’
6Press b to select ‘System.
7Press c/d to select a ‘System’.
8Press the BLUE coloured button to start scanning for the specified channel. If the channel is found it will be stored in the Recorder and will be available in the channel list and EPG.
Item
UHF Channel | The channel number you want to save | |
the manually tuned channel as. | ||
| ||
|
| |
Frequency | The frequency of the service (channel) | |
you are manually tuning. | ||
| ||
|
| |
Bandwidth | The bandwidth of the service (channel) | |
you are manually tuning. | ||
| ||
|
| |
System | The type of tuning system |
NOTE
•You can enter the UHF Channel and Frequency using the
General
First time installation
This function allows you to perform a first time installation (page 9).
25
29/06/2010 15:16:43