Initial auto installation

Quick guide

When the TV is powered on for the first time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.

Confirm the following before turning on the power

EIs the antenna cable connected? E Is the AC cord plugged in?

1Press a on the TV.

• The initial auto installation wizard appears.

2Setting the OSD language.

Press a/b/c/d to select the desired language.

3Setting the country.

Press ▲/▼/◄/► to select your country or area.

•This setting screen only appears during the first installation.

4Starting channel search.

Press ▲/▼ to select “Channel tuning” and then press OK.

•If you want to search for more broadcasts, execute “DTV (or ATV) manual tuning” from the menu “CHANNEL” (Page 18).

•To watch both analogue broadcasts and digital broadcasts, you should perform the channel search setting “DTV+ATV”.

5Selecting the TV location.

Home

Store

Press ◄/► to select where you will use this TV, and then press OK.

•HOME: For home.

•STORE: DYNAMIC mode is predetermined. If the “Picture Mode” is changed, the TV will automatically switch back to “DYNAMIC” when there is no signal input from the TV or remote control unit for 30 minutes.

If you have chosen “STORE” by mistake, go to “OPTION”

→“Restore Factory Default” → OK, and the TV returns to the initial screen.

6The TV searches for, sorts and stores all the receivable TV stations according to their settings and the connected antenna.

•To cancel the initial auto installation in progress, press END.

NOTE

•If you turn the power on the TV after performing step 4, initial auto installation wizard does not appear. The auto installation function allows you to execute the installation again from the “CHANNEL” menu (Page 18).

•The initial auto installation wizard will turn off if your leave the TV unattended for 30 minutes before searching for channels in step 4.

•After initial Auto Tuning is completed, the default PIN is automatically set to “1234”. To change the PIN setting, refer to “LOCK” menu on page 19.

Checking quality and signal strength

If you install a DVB-T antenna for the first time of relocate it, you should adjust the alignment of the antenna to receive a good reception while checking the antenna setup screen.

1Press a channel you want to check.

2Press MENU. “PICTURE” menu will appear.

3Press ◄/► to select “CHANNEL” menu.

4Press ▲/▼ to select “Signal Information” and then press OK.

5Position and align the antenna so that the maximum possible values for “Quality” and “Strength” are obtained.

NOTE

The values of “Quality” and “Signal Strength” indicate when to check the appropriate alignment of the antenna.