Quick guide
Turning on the power
Press a on the TV or B on the remote control unit.
Standby mode
Press B on the remote control unit when the TV is on.
•The TV enters standby mode and the image on the screen disappears.
•The B indicator on the TV changes from green to red.
•To completely turn off the power to the TV, unplug the AC cord from the AC outlet. However, do not unplug the AC cord unless otherwise instructed.
Display status indicator
Off | Power off. |
|
|
Red | The TV is in standby mode. |
|
|
Green | The TV is on. |
|
|
NOTE
•If you are not going to use this TV for a long period of time, be sure to remove the AC cord from the power outlet.
•Weak electric power is still consumed even when a is turned off.
•In DTV input mode, if the power is turned off immediately after a setting change from the menu screen, the new setting or channel information may not be memorised.
Initial auto installation (Analogue)
When the TV powers on for the first time after purchase, the initial auto installation (Analogue) is invoked. You can automatically set language, country and channels in successive operations.
NOTE
•The initial auto installation functions only once. If the initial auto installation is not completed, (ex: When menu screen disappeared by not operating for a few minutes, when the power shut down, etc.), try Auto Installation from the Setup menu. (See page 15.)
•The initial auto installation stops by pressing RETURN.
1 Setting the on-screen display language
1Press a/b/c/d to select the desired language listed on the screen.
2Press OK to enter the setting.
2 Setting the country or area
1Press a/b/c/d to select your country or area listed on the screen.
2Press OK to enter the setting.
• The programme auto search starts at the same time.
After this setting, auto search starts with the following order:
1Programme auto search
2Auto labelling
3Auto sorting
4Preset download
You do not need to do anything during the auto search.
The setup menu disappears and you can watch the programme on channel 1.
Using the analogue programme list
You can also select the desired channel from programme list instead of using
1 Press OK when no other menu screen is displayed. (Except external input.)
2 Press a/bto select the desired channel to tune in, and then press OK.
3 Press END to exit the Programme List.
Initial auto installation (DTV)
Digital Video Broadcasting is a transmission scheme. It is much more than a simple replacement for existing analogue television transmission. DVB provides more stations, clearer picture quality and other services displayed on the screen. It also allows a range of new features and services including subtitles and multiple audio tracks.
To watch DTV broadcasts, follow the procedures below to scan all available services in your area.
1 Press DTV or b to access the DTV mode.
2 Press DTV MENU and the DTV Menu screen displays.
3
4 Press a/bto select “Auto Installation”, and then press OK.
If you have already set the PIN, enter it here. If not, enter the factory preset PIN “1234”.
•See page 17 for setting PIN.
•A confirmation message displays. Press c/d to select “Yes”, and then press OK to start the search.
5 The TV starts scanning all available DTV and radio services in your area.
NOTE
•The language and country settings used in this operation are the settings you have already set while executing the Initial auto installation (Analogue). If you want to reconfigure the country setting, for instance after moving to another country, conduct “Auto Installation” from the Analogue Menu again.
•The services are stored according to the channel number information embedded in the stream (if available). If the information is not available, the services are stored according to the order in which they were received.
If you would like to sort the order, it is possible to arrange it as explained in page 24.
•To cancel the scan in progress, press END.
•You cannot select any
8