Sharp LC-70LE600U Preparation, Antennas, Installing Batteries in the Remote Control Unit

Page 10

Preparation

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set.

1.A 75-ohm system is generally a round cable with F-type connector that can easily be attached to a terminal without tools (Commercially available).

2.A 300-ohm system is a fl at “twin-lead” cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter (Commercially available).

F-type connector

75-ohm coaxial cable (round)

300-ohm twin-lead cable (fl at)

NOTICE F-type connector should be finger-tightened only.

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)

Connecting Antenna Cable

F-type connector

75-ohm coaxial cable

Connect the antenna cable to the TV using one of the methods in the illustration as shown (1, 2, 3 or 4).

1Cable without a CATV converter

2VHF/UHF antenna

3Combination VHF/ UHF antenna

4Separate VHF/UHF antenna

 

 

 

Home Antenna

 

Cable TV lead-In

 

terminal (75-ohm)

 

 

 

 

 

 

 

Coaxial cable

 

 

 

(commercially available)

 

 

 

Home Antenna

 

75-ohm coaxial cable (round)

terminal (75-ohm)

 

 

 

 

 

 

Coaxial cable

 

 

 

(commercially available)

 

75-ohm coaxial cable (round)

 

 

 

 

 

or

 

 

 

 

300/75-ohm adapter

 

300-ohm twin-lead cable (flat)

(commercially available)

 

 

 

 

UHF

300-ohm

 

 

VHF

ANTENNA

 

 

twin-lead cable

IN

OUT

 

ANTENNA

 

 

 

 

 

 

 

Combiner

 

 

 

(commercially available)

 

300-ohm twin-lead cable

 

To TV antenna

 

 

 

 

or 75-ohm coaxial cable

 

terminal

 

 

Installing Batteries in the Remote Control Unit

If the remote control fails to operate TV functions, replace the batteries in the remote control unit.

1 Open the battery cover.

2 Insert two “AA” size batteries

3 Close the battery cover.

 

(supplied with the product).

 

Place the batteries with their terminals corresponding to the (e) and (f) indications in the battery compartment.

CAUTION

Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.

Do not mix batteries of different types. Different types of batteries have different characteristics.

Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.

Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin can cause a rash. If you fi nd any chemical leakage, wipe thoroughly with a cloth.

The batteries supplied with this product may have a shorter life expectancy due to storage conditions.

If you will not be using the remote control unit for an extended period of time, remove batteries from it.

10

Image 10
Contents Supplied Accessories LC-70LE600U LC-60LE600UFor connections 12P07-MX-NMImportant Information Additional Safety Information Dear Sharp CustomerPrecautions when transporting the TV Caring for the CabinetChild Safety Caring for the Liquid Crystal panelRemoving the Stand Attaching the Stand1Insert the stand into the openings on the bottom of the TV Setting the TV on the Wall Optional AccessoryInsert the batteries into the remote control unit. See Using the Remote Control UnitExperiencing HD images Preparation Installing Batteries in the Remote Control UnitConnecting Antenna Cable AntennasPart Names TV Front TV Rear/SideConnecting an Audio Amplifier Connecting to External EquipmentConnecting a PC Watching TV Turning On/Off the PowerInitial Installation Press c/d to select Air or Cable, and then press EnterDirect Button Operation Changing VolumeSleep Timer Changing ChannelsDigital broadcasting audio mode MTS/SAP stereo modeDirect Button Operation Closed Captions and Digital Closed Captions Operating On-Screen Display MenuZoom For PC input modeFor HD programs For 43 programsOn-Screen Display Menu Using the remote controlUsing the control panel of the main unit On-Screen Display Menu OperationPicture Menu OPC SettingAdvanced Picture Setting PicturePower Control Menu Audio MenuSetup Menu Parental Ctrl Parental Control Setting ResetLanguage Repeat the same steps for the other items Content rating items are setOn-Screen Display Menu TV Parental Guidelines Mpaa Voluntary movie rating systemCanadian French Ratings How to temporarily release the V-CHIP BlockCanadian English Ratings Reactivating the temporarily released V-CHIP BlockOption Menu Software Update Auto Sync. for Analog PC Input Mode OnlyIdentification Troubleshooting AppendixPC Compatibility Chart below Troubleshooting Error MessagePC Compatibility Chart AppendixSpecifications Model LC-70LE600U Model LC-60LE600UInformation on the Software License for This Product Calling for Service Limited WarrantyPage Dimensional Drawings