Preparation and Watching TV
Using the remote control
Use the remote control unit by pointing it towards the remote control sensor. Objects between the remote control unit and sensor may block proper operation.
Remote control sensor |
|
|
| (7 m) | |
|
|
| |||
|
|
|
|
| |
30º (5 m) |
|
|
|
|
|
Horizontal & Vertical | 0º |
|
|
| |
|
|
| |||
•If you are not going to use the remote control for a long time, remove the batteries to avoid damaging remote control caused by chemical leakage.
Display the Menu Screen
Press MENU on the remote control to display the menu screen.
Select an item by the remote control
Main Menu | Picture | 1/2 |
| Smart Picture | Standard |
Picture | Backlight | 90 |
Sound | Contrast | 90 |
Brightness | 50 | |
TV | Saturation | 50 |
Sharpness | 10 | |
Setup | Tint | 0 |
Colour Temperature | Normal | |
Parental | 16:9 Overscan | On |
| Advanced Video |
|
Select | EXIT RETURN | OK Access |
3
1.Press
to select the desired menu.
2. Press to select / adjust the item to the desired level. The new setting on the screen is applied immediately.
3.Press EXIT to return to the previous layer.
Exit the Menu Screen
Press EXIT or Menu to exit the menu screen.
Run the auto installation
Follow the onscreen instructions to select your preferred Language, Country, and Location.
Daily operation
Turning on/off the power
Turn on the power by pressing the button on the TV. Turn off the power by pressing again the button on the TV.
Changing channels
Change channels by pressing P | button. |
Standby mode
ETo standby mode
If the TV set is switched on, you can switch it to standby mode by pressing Bbutton on the remote control.
ESwitching on from standby
To switch on from standby mode, press B button on the remote control.
TV indicator status
B indicator | Status |
|
|
Off | Power off |
|
|
Red | Standby |
|
|
Blue | Power on |
NOTE
•If you are not going to use this TV for a long period of time, be sure to remove the AC cord from the power outlet.
•A small amount of electric power is still consumed even when the power is turned off.
Selecting external video source
Once the connection is done, press B button to display the Input Selection screen, and then press 
button to switch over to the appropriate external source, and press with OK button to confirm.
- 5