Menu operations
Child Lock | TV only |
|
|
Allow you to use a PIN to protect certain settings from being accidentally changed.
Changing the PIN
1
2
3 Press a/bto select “Child Lock”, and then press OK.
Change PIN |
Reset |
New PIN |
|
|
|
|
– | – | – | – | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Reconfirm | – | – | – | – |
|
|
|
|
|
|
|
|
|
|
4
5 Enter the same 4-digit number as in step 4 to confirm.
•“The system PIN has been changed successfully” displays.
NOTE
•To view a locked channel, you must enter a PIN. (See pages 16 and 27 for locking channels from viewing in analogue TV and DTV mode.) When you select a locked channel, a PIN prompt message pops up. Press OK to display the PIN input window.
Resetting the PIN
Allow you to reset your PIN to the factory preset “1234”.
1 Repeat steps 1 to 3 in Changing the PIN.
2 Enter the PIN.
3 Press a/bto select “Reset”, and then press OK. 4 Press c/dto select “Yes”, and then press OK.
NOTE
•As a precautionary measure, make a note of your PIN on the back of this operation manual, cut it out and keep it in a safe place that children cannot reach.
•See page 32 for resetting the current PIN to the factory preset “1234” if you lose or forget your PIN.
Input Label
You can assign each input source a label you like.
1 Press b to select the desired input source.
2 Press MENU and the MENU screen displays.
3 Press c/dto select “Setup”.
4 Press a/bto select “Input Label”, and then press OK.
5 Press a/b/c/dto select each character of the new name for the input source, and then press OK.
6 Repeat step 5 above until the name is fully spelt out, and then press OK.
•The name can be 6 characters or less.
•If a label name is less than 6 characters, select “END”, then press OK.
NOTE
•You cannot change the label if the input source is TV or DTV.
Fine Sync. | PC only |
|
|
Menu Operation: C (Page 12)
Ordinarily, the TV automatically adjusts image positions coming from PC (Auto Sync. function). In some cases, however, manual adjustment is needed to optimise the image.
Item
Clock: Adjusts when the image flickers with vertical stripes.
Phase: Adjusts when characters have low contrast or when the image flickers.
NOTE
•If you need to adjust the image position, adjust the position using your PC.
17