Sharp LC-32SH130K operation manual Safety Precautions

Page 5

Safety Precautions

Read the following recommended safety precautions carefully for your safety.

Power Source

The TV set should be operated only from a 220-240V AC, 50Hz outlet. Ensure that you select the correct voltage setting for your convenience.

Power Cord

Do not place the set, a piece of furniture, etc. on the power cord (mains lead) or pinch the cord. Handle the power cord by the plug. Do not unplug the appliance by pulling from the power cord and never touch the power cord with wet hands as this could cause a short circuit or electric shock. Never make a knot in the cord or tie it with other cords. The power cords should be placed in such a way that they are not likely to be stepped on. A damaged power cord can cause fire or give you an electric shock. When it is damaged and needs to be replaced, it should be done by qualified personnel.

Moisture and Water

Do not use this device in a humid and damp place (avoid the bathroom, the sink in the kitchen, and near the washing machine). Do not expose this device to rain or water, as this may be dangerous and do not place objects filled with liquids, such as flower vases, on top. Avoid from dripping or splashing.

If any solid object or liquid falls into the cabinet, unplug

the TV and have it checked by qualified personnel before operating it any further.

Cleaning

Before cleaning, unplug the TV set from the wall outlet. Do not use liquid or aerosol cleaners. Use soft and dry cloth.

Ventilation

The slots and openings on the TV set are intended for

ventilation and to ensure reliable operation. To prevent overheating, these openings must not be blocked or covered in anyway.

Heat and Flames

The set should not be placed near to open flames and sources of intense heat such as an electric heater. Ensure that no open flame sources, such as lighted candles, are placed on top of the TV. Batteries should not be exposed to excessive heat such as sunshine, fire or the like.

Lightning

In case of storm and lightning or when going on holiday, disconnect the power cord from the wall outlet.

Replacement Parts

When replacement parts are required, make sure that the service technician has used replacement parts, which are specified by the manufacturer or have the same specifications as the original one. Unauthorized substitutions may result in fire, electrical shock or other hazards.

Servicing

Please refer all servicing to qualified personnel. Do not remove the cover yourself as this may result in an electric shock.

Waste Disposal

Packaging and packaging aids are recyclable and should principally be recycled. Packaging materials, such as a foil bag should be kept away from children

Batteries, including those which are heavy metal free, should not be disposed of with household waste. Please dispose of used batteries in an environmentally friendly manner. Find out about the legal regulations which apply in your area.

Do not try to recharge batteries, there is a danger of explosion. Replace batteries only with the same or equivalent type.

This symbol on the product or on its packaging means that your electrical and electronic device should be disposed at the

end of its service life separately from your household wastes. There are separate collection systems for recycling in the EU. For more information, please contact the local authority or the dealer where you purchased the product.

Disconnecting the Device

The mains plug is used to disconnect the TV set from the mains and therefore it must remain readily operable.

Headphone Volume

Excessive sound pressure from earphones and headphones can cause hearing loss.

Installation

To prevent injury, this device must be securely attached to the wall in accordance with the installation instructions when mounted to the wall (if the option is available).

LCD Screen

The LCD panel is a very high technology product with about a million thin film transistors, giving you fine picture details. Occasionally, a few non-active pixels may appear on the screen as a fixed blue, green or red point. Please note that this does not affect the performance of your product.

Warning! Do not leave your TV in standby or operating mode when you leave your house.

Connection to a Television Distribution System (Cable TV etc.) from Tuner

Device connected to the protective earthing of the building installation through the mains connection or through other apparatus with a connection to protective earthing-and to a television distribution system using coaxial cable, may in some circumstances create a fire hazard.

Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11).

Note:The HDMI connection between PC and TV may cause radio interference in which case it is recommended to use VGA(DSUB-15) connection.

The Standby Off/On button doesn´t separate this device completely from mains. Moreover the device consumes power in the standby operation. In order to separate the device completely from mains, the mains plug has to be pulled from the mains socket. Because of that the device should be set up in a way, that an unobstructed access to mains socket is guaranteed, so that in case of emergency the mains plug can be pulled immediately. To exclude the danger of fire, the power cord should principally be separated from the mains socket prior to a longer period of non-usage, i.e. during vacations.

“HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.”

Manufactured under license from Dolby Laboratories.

English - 4 -

Image 5
Contents LC-32SH130K Contents Dear Sharp customer FeaturesIntroduction PreparationPrecautions when transporting the TV Important safety precautionsSafety Precautions Environmental Information Package ContentsRemote Control Buttons LCD TV and Operating Buttons Viewing the Connections Back ConnectorsFront and Rear View Control buttons View Hdmi 2 Hdmi Input Hdmi 1 Hdmi InputPower Connection Viewing the Connections Side ConnectorsUsing USB Inputs Aerial ConnectionProgramme Recording Connecting to a DVD Player via HdmiUsing Side AV Connectors Connecting the LCD TV to a PCRemote Control Handset Switching On/OffViewing Electronic Programme Guide EPG Programme Selection Direct AccessProgramme Selection Previous or Next Programme Recording via EPG ScreenFirst Time Installation Managing Stations Channel List InstallationManual Tuning On-Screen Information Managing Stations FavouritesManaging Stations Sorting Channel List Viewing Videos via USB Media Playback Using Media BrowserViewing Photos via USB Slideshow OptionsTimeshift Recording Media Browser SettingsInstant Recording Recordings LibraryChanging Image Size Picture Formats Watching Recorded ProgrammesConfiguring Picture Settings Using a Conditional Access Module Configuring Sound SettingsConfiguring Your TV’s Settings Parental Control Configuring Language PreferencesConfiguring Date/Time Settings TimersRecording Configuration Configuring Other Settings Configuring Source SettingsOther Features OperationTips TeletextColoured Buttons RED/GREEN/YELLOW/BLUE Teletext function buttons are listed belowNot Available, O Available Appendix a PC Input Typical Display ModesAppendix D Supported File Formats for USB Mode Appendix C Supported DVI ResolutionsSupported Players Stream Audio Decoder MsadAppendix E Software Upgrade BatterySoftware upgrade search via user interface AM search and upgrade modeDigital Reception SpecificationsDimensions mm Dimensional Drawings End of life disposal Detachable Stand Uninstallation Method Screw Dimensions