Sharp LC-22LE510K Connecting the LCD TV to a PC, Using Side AV Connectors, Remote Control Handset

Connecting the LCD TV to a PC

For displaying your computer’s screen image on your LCD TV, you can connect your computer to the TV set. Power off both computer and display before making any connections. Use 15-pin D-sub display cable to connect a PC to the LCD TV. When the connection is made, switch to PC source. See “Input selection” section. Set the resolution that suits your viewing requirements. Resolution information can be found in the appendix parts

	PC VGA Cable
	(Not supplied)
PC Input
(back)	Or
	Side Audio/Video
	Connection Cable
	(Supplied)
SIDE AV	PC Audio Cable
.Side AV Input	(Not supplied)

Using Side AV Connectors

You can connect a range of optional equipment to your LCD TV using side connectors of the TV.

•For connecting a camcorder or camera , you should use AV socket (side). To do this, you must use the supplied video/audio connection cable. First, plug single jack of the cable to the TV’s AV IN socket (side). Afterwards, insert your camera cable’s (not supplied) connectors into the socket part of the video/audio connection cable. Colours of the connected jacks should match. See illustration below.

•Afterwards, you should switch to Side AV source. See the section Input selection in the following sections for more information.

AV Connection	AV Cable
Cable (supplied)	(not supplied)

Remote Control Handset

Inserting Batteries

•Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

•Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover.

Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC 50 Hz.

•Switch the “” button on the bottom right hand side under the screen to position “” so the TV will switch to standby mode. Then the standby LED lights up.

•To switch on the TV from standby mode either:

•Press the “” button, CH / CH or a numeric button on the remote control.

•Press the “” or +/- button on the TV.

•The TV will then switch on.

Note: If you switch on your TV via CH / CH buttons on the remote control or on the TV set, the programme that you were watching last will be reselected.

SIDE AV

Headphone

Camera

By either method the TV will switch on.

To Switch the TV to Standby

To switch the TV to low power stand by press the

“ ” button on the remote control or right hand side

•To listen the TV sound from headphones, you should connect headphones to your TV by using the

HEADPHONE jack as illustrated above..

of the TV.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

To Switch the TV Off

•Switch the “” button on the bottom right hand side under the screen to position 2 as illustrated,

to isolate the TV from the mains, the LED will go out.

English - 13 -

00_MB60_[GB]_1910UK_IDTV_PVR_BRONZE17_22942LED_YPBPR_ ROCKER_10072632_50186842_td01.indd 13 06.07.2011 17:31:31