Technika LCD19-919 Analogue TV Menu System, Picture Menu, Channel Search, Clear Service List

Channel Search

In manual channel scan, the number of the multiplex is entered manually and only that multiplex is searched for the channels. For each valid channel number, signal level and signal quality are shown on the screen.

In both manual and auto search any existing channel in the database is not re-stored to avoid redundant duplicates of that channel.

Clear Service List (*)

(*)This setting is visible only when the Country option is set to Denmark, Sweden, Norway or Finland.

Use this setting to clear channels stored. Press “” or “” button to select Clear Service List and then press OK. The following OSD message will be displayed on the screen:

Highlight NO and press OK to cancel. Select Yes by pressing “” or “” button and press OK to delete all of the channels.

First Time Installation

The user can use this item to load default settings, which were loaded to the receiver at the factory.

To install factory settings, highlight “First Time Installation” menu item and press “OK” button, then you will be asked whether or not to delete the settings. Selecting “Yes” by pressing “OK” button while “Yes” is highlighted will delete the existing channel table.

Then you will be asked to confirm for deleting all channels and settings:

By selecting Yes and pressing the “OK” button, the existing channel table will be deleted. After factory settings are loaded, “First Time Installation” menu will be displayed.

The menu which is displayed for language selection appears on the screen at first. By using “” or “” buttons, select the desired language option, and press OK button to activate.

Afterwards “First time installation” OSD will appear on the screen. By pressing “” or “” buttons, select the Country you want to set and press “OK” button (* only for EU countries).

Press the “OK” button to start installation. After search is completed for digital channels, a message asking whether to search for analogue channels appears on the screen.This process is same as described in Automatic Search section..

Analogue TV Menu System

Picture Menu

Mode

For your viewing requirements, you can set the related mode option.

Press “” or “” button to select Mode. Press “” or “” button to choose from one of these options: Natural, Cinema and Dynamic.

Contrast/Brightness/Sharpness/Colour/ Hue

Press “” or “” button to select the desired option. Press “” or “” button to set the level.

Note: Hue option can only be visible when the TV receives an NTSC signal.

Colour Temp

Press “” or “” button to select Colour Temp. Press “” or “” to choose from one of these options: Normal, Warm and Cool.

Note:

•For normal colours, select Normal option.

•Setting Warm option gives white colours a slight red stress.

•Setting Cool option gives white colours a slight blue stress.

Noise Reduction

If the broadcast signal is weak and the picture is noisy, use Noise Reduction setting to reduce the noise amount.

English - 18 -

MB45_[GB]_1205UK_IDTV_BRONZE11_19882W_10066964_50164988.indd 18 15.02.2010 14:40:18