Technika 23-231-BB manual ATTACHING/DETACHING the Stand, Attaching the Stand, Detaching the Stand

Attaching / detaching the stand and wall mounting

ATTACHING/DETACHING THE STAND

Attaching the Stand

1) Insert the TV into the stand at 45 degrees	2) Twist the TV into the CLOSE
	position until it clicks into place

This television requires a VESA 100 wall mount, or equivalent.

Detaching the Stand

1)To remove the base, press close and rotate 45 degrees.

2)Remove the 4 screws highlighted

3) Remove the screw/s in the neck of the stand (where fitted)

IMPORTANT - Before drilling any holes in the wall ensure you are not drilling where there could be any electric wires, water or gas pipes.

Wall mounting the TV

1)Remove the four screws highlighted below.

2)The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes are indicated in the picture below.

fig 1 TV

Viewing angle

For optimum viewing, if wall mounting the TV higher than eye level, the TV should be tilted downwards so that the TV’s screen is ‘face on’. See fig 1 and 2

Important – If wall mounting this TV, only use the screws already provided in the wall mounting holes. Using other screws which are longer could cause irreparable damage to internal parts.

fig 2

TV

Viewing angle

IMPORTANT NOTE. Occasionally we may release new software/firmware upgrades/enhancements	9
for this television. Please check the ‘firmware upgrade’ section of the website regularly.

TEchnika Manual 23-50 colour models .indd Sec1:9

20/01/2010 14:11:07