Getting Started - Initial Set Up
GETTING STARTED - INITIAL SET UP
1)Using the RF cable supplied, connect the TV to the TV Aerial wall socket (Fig A)
2)Connect the power cable to the Electrical outlet (Fig B)
Fig A
3)Switch on the television using the power on/off switch located on the side of the TV.
Power on/off
Fig B
4)Insert the batteries supplied into the Remote control and press the Standby button to power on the TV
OFF |
|
DISPL | SLEEP |
PICTURE SOUND SUBTITLE
PRESETS
AUDIO | LANG | ASPECT FREEZE |
5)You will now be welcomed with the initial
If it does not appear, on the remote control, please press [MENU] then
Press OK on the remote control and follow the steps to begin tuning.
6)Once tuning has finished the following screen will appear.
If you are missing channels, the reason for this is likely to be signal strength, you should consider connecting signal booster and
Tip: If the TV finds some, but not all, of the Digital channels, the TV is functioning correctly but the signal being received is not strong enough. (The signal strength needs to be above 85% - you can see the signal strength the TV is receiving when you change channels/ programmes) you will need to increase the signal reception in order to receive all of the channels available. The most economical way to do this is by purchasing and connecting a ‘signal booster’ in between the TV and the TV aerial socket. If this does not solve the problem, you will need to upgrade the TV aerial to a digital
IMPORTANT NOTE. Occasionally we may release new software/firmware
upgrades/enhancements for this television. Please check the ‘firmware11 upgrade’ section of the website regularly.
Technika 40 LED.indd Sec1:11
25/02/2010 17:37:42