GETTING STARTED - INITIAL SET UP
IMPORTANT - AFTER TUNING DO NOT PRESS ANY BUTTONS FOR 20 SECONDS SO THE CHANNEL
INFORMATION CAN BE STORED.
TUNING IN
IMPORTANT — Please ensure the TV has reached room temperature before connecting the power for the first time
1)Connect the mains lead to your electrical outlet
2)Connect the RF cable supplied to the 'RF IN' on the rear of the TV and connect
the other end of the cable to your TV Aerial outlet
RF IN
3)Switch on the television using the rocker switch located on the side of the TV
4)Install batteries in the remote control and press the [STANDBY] button to turn on the TV.
INFO
The ‘First Time Installation’ menu should now appear. If it does not, please press
5)Press [OK] on the remote control whilst ‘OK’ is highlighted on screen.
| First Time Installation |
Country | UK |
|
|
Language | English |
|
|
Please ensure that the aerial is connected to the connector labelled ‘ RF In ’ on the rear of the TV .Ensure that OK is highlighted in yellow and press ‘OK’ on your remote .If after this scan ,not all digital channels are found ,your aerial may require a signal booster .alternatively ,upgrade your aerial to a high gain digital version .
OK | Cancel |
Tuning will now take place.
If no channels are found the following screen will appear, please refer to additional information below.
First Time Installation
Unfortunately the TV did not find any channels Please check your aerial connection
and refer to the user manual Do you wish to re tune your TV
Yes | Do it next time |
| No |
TYPICAL SET-UP
Connect between TV and TV
Aerial socket
Signal Booster
Once you have connected a 'Signal booster' you will need to retune the TV in order to receive all of the channels.
If the TV finds some, but not all, of the Digital channels, the TV is
functioning correctly but the signal being received is not strong enough. (The signal strength needs to be above 85% - you can see the signal strength the TV is receiving when you change channels/ programmes) you will
need to increase the signal reception in order to recieve all of the channels
available. The most economical way to do this is by purchasing
and connecting a 'signal booster' in between the TV and the TV aerial socket.
If this does not solve the problem, you will need to upgrade the TV
10 | aerial to a digital |