Symphonic MSD513E Preparation for USE, ANTENNA/CABLE Connections, VHF/UHF Combined Antenna

Page 10

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

Satellite Box or Cable Box (Not supplied)

From

Cable System

OUT

From Cable System or

Satellite Dish

Rod Antenna

VHF/UHF Antenna

(Supplied)

(Not supplied)

 

IN

 

 

 

 

VHF Antenna

 

 

(Not supplied)

 

 

UHF Antenna

 

or

(Not supplied)

COAXIAL ANT.

VHF/UHF

 

 

or Combiner

 

 

(Not supplied)

 

ANT.

75-ohm Coaxial

or

 

Cable (Not supplied)

 

or

Flat twin-lead cable

[Fig. 4]

 

 

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

NOTE:

Before plugging the antenna into the ANT. IN jack of the TV/DVD, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. IN jack of the TV/DVD.

Bent pin

Cable Plug

(Needs to be straightened)(Straight pin)

VHF/UHF COMBINED ANTENNA

The VHF/UHF Rod Antenna (supplied) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the TV/DVD. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. terminal of the TV/DVD as shown in the diagram above. For the best reception, fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor antenna.

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/DVD without a converter box. Use the TV/ DVD Remote Control to select channels.

CABLE WITH CONVERTER/DESCRAM- BLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown here.

Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/ DVD Remote Control.

TO VIEW A SCRAMBLED/UNSCRAMBLED CHANNEL

1.Set the TV/DVD channel selector to the output channel of the Cable Converter Box or Satellite Box. (Ex. CH3)

2.Select the channel to view on your Cable Converter Box or Satellite Box.

– 10 –

EN

0C28

Image 10
Contents RSMSD513E 13 inch Important Safeguards S2 8 9 8 a Important Copyright Information PrecautionsLaser Safety RADIO-TV InterferenceLocation Supplied AccessoriesAvoid the Hazards Electrical Shock and Fire Table of Contents Features TV ModeOperating Controls and Functions TV/DVD Front PanelInstalling the Batteries TV/DVD Rear ViewVHF/UHF Combined Antenna Preparation for USEANTENNA/CABLE Connections VHF/UHF Separate AntennasConnecting to External Input Jacks Connecting to AN Amplifier Equipped with DigitalConnecting to a Dolby Digital Decoder for DVD Channel SET UP SET UP for USESelecting the Language Deleting or Adding Channels Degaussing TV OperationWatching a TV Program Picture ControlWhen the Closed Caption Mode is on Sleep TimerTo Cancel the Closed Caption System To cancel the sleep timerWhen you select TV-Y7 Chip SET UPTV Rating SET UP When you select TV-PG, TV-14 or TV-MAMpaa Rating SET UP Change Access CodeDVD About the DiscsPlayable Discs Disc Types Audio CDDisc Menu Basic Playback General FeaturesPlaying a Disc Title MenuStep by Step Playback ResumePause Fast FORWARD/REVERSE SearchTrack Search Time Search Marker Setup ScreenSearch Function Title / Chapter SearchRepeatprogram Special Playback FunctionRandom Playback Program Playing a MP3 DiscMP3 Playback RepeatChanging the Settings ON-SCREEN Information DVD-V CD MP3Changing the DVD Setup Items Language SettingWhen playing disc with copyright Protection Display Setting Audio SettingsEnter Parental Control InitializeTroubleshooting Guide Problem Corrective ActionClosed Caption Problem Possible Remedy DVDDisc Handling MaintenanceCabinet Cleaning ServicingElectrical Specifications SpecificationsGeneral Specifications Other SpecificationsConsulte la figura 2 de la página Controles DE Operación Y FuncionesConsulte la figura 1 de la página Consulte la figura 3 de la páginaConexiones DE ANTENA/CABLE Preparación Para LA UtilizaciónPara Insertar LAS Pilas Antena Combinada DE VHF/UHFAntena Separadas DE VHF/UHF Conexión a Tomas DE Entrada ExternaConexión a UN Para VER UN Canal CODIFICADO/DECODIFICADOSelección DE Idioma Conexciona UN Decodificador DolbyConsulte la figura 7 de la página Ajuste DE Canal Ajuste DE CanalReproduccion Basica Autoprogramacion DEMemo Tel DurationPlease do not Ship Your Unit to the Teterboro Address