Connections & Setup
Step 3: Configuring for a VCR
1.If your TV is connected to a VCR, press OK.
If it is not, highlight No and press OK (a screen appears reminding you to connect your
2.Use the up and down arrow buttons to highlight the brand of your VCR that is connected to the TV.
If your brand isn’t listed, highlight Not Listed and press OK.
3.Tune your VCR to channel 02. Next, turn OFF your VCR. When you complete these steps, press OK to begin testing.
Important Note: When code testing is in pr ogr ess, don’ t touch your TV , VCR, or any of the r emote contr ols for these pr oducts.
4.Look at the front display of your VCR. If your VCR turned on automatically and changed to channel 09, the test was successful. Highlight Yes and press OK.
If your VCR didn’t change to channel 09, you can either choose No or Test this code again.
If you think your TV or remotes might have been touched during the test, tune your VCR to channel 02, turn off your VCR and highlight Test this code again.
If you don’t think the test was interrupted, highlight No. Tune your VCR to channel 02 and turn off your VCR. Press OK (the GUIDE Plus+ system starts testing another set of codes.)
Keep following the previous instructions until the VCR finds the correct code.
18 | Chapter 1 |