GETTING STARTED
•Later, after you have turned on the TV, adjust the length and position of the antenna for best reception.
•For viewing VHF channels
•For viewing UHF channels
•For listening to the radio, if necessary, adjust the antenna rods for best reception.
11. Slide TV onto Bracket
The TV must be slightly below the cabinet overhang when installed in the bracket. Some clearance is necessary so the TV can be easily rotated to the desired viewing angle or removed for portable use.
• Slide the TV onto the mounting hook of the bracket and push it all the way back until the hook on the bracket locks into the back of the TV. You should hear the TV click into place.
•Secure the TV in the bracket by sliding the locking tab on the back of the bracket into the bracket assembly.
•To remove the TV, slide the locking tab out of the bracket assembly.
• Lift the TV up and gently pull forward.
12. Attach AC Power Cord
•First attach the AC power cord to the
back of the TV.
• Then extend the cord and plug it into an electrical outlet.
13.Attach Cord Hooks
•You can use the cord hooks to hold the cord out of the way.
•For the most attractive appearance, place the cord hooks at the back edge of the cabinet (on or next to the wall) directly above the outlet to be used.
•To attach the cord hooks, peel off the adhesive back and attach the
hooks to a clean, dry surface on underside of cabinet or back wall.
•Use the cord tie that is attached to the power cord to wrap and tie excess cord out of sight.
Warning
Make sure the locking slide is pushed fully into the locked position. Failure to lock the sliding tab into position may allow the TV to fall off the barcket causing personal injury or damage to the TV. Push the sliding tab into the bracket assembly until you hear a click.
6