Precautions, Disposal of Plug, Replacing Fuse

PRECAUTIONS

THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE. TO ENSURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS OR ATTEMPT TO GAIN ACCESS TO THE INSIDE OF THE PRODUCT. REFER ALL SERVICING TO QUALIFIED PERSONNEL.

-The apparatus shall not be exposed to dripping or splashing.

-No objects ﬁlled with liquids, such as vases, shall be placed on the apparatus.

-Do not use where there are extremes of temperature (below 5°C or exceeding 35°C) or where direct sunlight may strike it.

-Because of the DVD recorder's extremely low noise and wide dynamic range, there might be a tendency to set the volume on the ampliﬁer unneces- sarily high. Doing so may produce an excessively large output from the ampliﬁer which could damage your speakers.

-Sudden changes in the ambient temperature may cause condensation to form on the optical lens inside the unit. If this happens, take out the disc, leave the unit for about 2 hours, and then proceed to operate.

-When carrying the unit, be sure to remove a disc which may be inside and turn the power off. Wait at least 10 seconds, then unplug the mains lead from the AC outlet. Carrying the unit with a disc inside may damage the disc and/or the unit.

-Do not install this equipment in a conﬁned space, such as a book case or built-in cabinet.

-The unit must be operated in a horizontal position only. The unit must be placed in a well ventilated area.

Do not place any object on the top of the unit. Do not block ventilation holes.

The cabinet of the unit warms up when it is used for a long time, but it is not a malfunction.

Your SANYO product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste.

Please dispose of this equipment at your local community waste collection/recycling centre.

In the European Union there are separate collection systems for used electrical and electronic products. Please help us to conserve the environment we live in!

This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corpora- tion, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Recording copyright material without permission of the copyright owners is usually an infringement. If you wish to re-record copyright material, permission from the copyright owner is necessary. SANYO does not approve of, and cannot be held responsible for, any unlawful use of this machine.

IMPORTANT

If the plug supplied with this equipment is not suitable for the socket outlets in your home it should be cut off and replaced with the correct type.

Disposal of Plug

If the non rewireable plug is to be cut off, the removed plug should be disposed of carefully as there is a shock hazard should the plug be inserted into a live socket.

Replacing Fuse

The detachable fuse cover must be replaced after changing the fuse. Only a 3A fuse should be used and should comply with BS1362 and should carry the ASTA mark .

The wires in the mains lead are coloured in accordance with the following code;

Blue Neutral

Brown Live

The wires in the mains lead must be connected to the terminals in

the plug as follows;
Wire colour	Plug terminal marking
Blue	N or Black or Blue
Brown	L or Red or Brown

Do not connect either wire to the earth terminal.

If the mains plug contains a fuse this should be 3A, if a plug without a fuse is used the distribution board fuse should not be greater than 5A.

Disconnect the mains plug from the supply socket when not in use. Do not remove the back cover with mains connected.

The unit is not disconnected from the mains unless it is unplugged from the AC outlet.

Either the main unit or remote control can be operated. However, for convenience, this instruction manual explains operation using the remote control.

NOTE:

-This handling description is printed prior to product development.

-When a part of the product speciﬁcation must be changed to improve operability or other functions, priority is given to the product speciﬁca- tion itself.

-In such instances, the instruction manual may not entirely match all the functions of the actual product.

-Therefore, the actual product and packaging, as well as the name and illustration, may differ from the manual.

This set complies with the EMC Directive 89/336 and with the LVD Directive 72/23.