Sylvania LC370SS8M owner manual 5Troubleshooting Guide

Page 35

TROUBLESHOOTING

5Troubleshooting Guide

If the unit does not perform properly when operated as instructed in this owner’s manual, check the following chart once before calling for service.

Symptom

Remedy

No power

• Be sure the power cord is plugged in.

 

• If a power failure occurs, unplug the power cord for 30 minutes to allow the unit to

 

reset itself.

No picture or sound

• Check if the power is on.

 

• Check the outlet connection.

 

• Check the antenna or cable connection to the main unit.

 

• When the outside antenna is used, check the wire condition and connection.

 

• View other TV channels. The problem might be limited to the broadcasting station.

 

• Turn off the power and wait for about 1 minute, then turn it on again.

No color

• Check the antenna or cable connection to the main unit.

 

• When the outside antenna is used, check the wire condition and connection.

 

• View other TV channels. The problem might be limited to the broadcasting station.

 

• Adjust the “Color” in the main menu.

Sound OK, picture poor

• Check the antenna or cable connection to the main unit.

 

• When the outside antenna is used, check the wire condition and connection.

 

• Electrical interference from nearby appliances may affect picture quality.

 

• Adjust “Contrast” and “Brightness” in the main menu.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Picture distorted

• When the outside antenna is used, check the wire condition and connection.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Weak picture

• Check the antenna or cable connection to the main unit.

 

• When the outside antenna is used, check the wire condition and connection.

 

• Adjust “Contrast” and “Brightness” in the main menu.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Lines or streaks in picture

• When the outside antenna is used, check the wire condition and connection.

 

• Electrical interference from nearby appliances may affect picture quality.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Picture blurred

• When the outside antenna is used, check the wire condition and connection.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Ghosts in picture

• Check the antenna or cable connection to the main unit.

 

• When the outside antenna is used, check the wire condition and connection.

 

• Electrical interference from nearby appliances may affect picture quality.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Bars on TV screen

• When the outside antenna is used, check the wire condition and connection.

 

• Electrical interference from nearby appliances may affect picture quality.

Picture rolls vertically

• When the outside antenna is used, check the wire condition and connection.

 

• Electrical interference from nearby appliances may affect picture quality.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Different color marks on TV

• Move the unit away from nearby electric appliances. Turn off the power and wait

screen

30 minutes before turning it back on.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Poor reception on some

• Check the antenna or cable connection to the main unit.

channels

• When the outside antenna is used, check the wire condition and connection.

 

• Electrical interference from nearby appliances may affect picture quality.

 

• View other TV channels. The problem might be limited to the broadcasting station.

Picture OK, sound poor

• View other TV channels. The problem might be limited to the broadcasting station.

 

 

No reception of digital signals

• Make sure auto channel scan has been completed. (Refer to “Auto Channel Scan”

 

on page 14.)

 

Auto channel scan must be completed when you set up the unit for the first time

 

or move it to a location where previously unavailable channels are broadcast.

 

• The selected channel may not be broadcasting.

 

• When auto channel scan is interrupted and not completed, some channels will not

 

be received. Make sure to complete. (Refer to “Auto Channel Scan” on page 14.)

INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION

35

EN

Image 35
Contents LC370SS8 M Important note is located on the rear of the cabinet IntroductionRADIO-TV Interference PrecautionsLocation 5Supplied Accessories5Symbols Used in this Manual Quick start guide Remote controlDTV/TV/CATV FeaturesContents 5Installing the Batteries 5Remote Control Function5Control Panel Connection to Cable Box or Satellite Box Connection5Basic Connection Antenna Cable ConnectionHDMI-DVI Connection 5External Device ConnectionHdmi Connection Video Cable Connection Component Video Cable ConnectionAnalog Video ConnectionAudio Output Connection Digital PC Connection Scanning and memorizing of channels start automatically Initial Setting5Initial Setup Make sure if the unit is connected to antenna or cable5Auto Channel Scan 5Main MenuEnter 5Language Selection5Channel Selection 5Volume AdjustmentWhat is the minor channel? Watching TVYou can freeze the image shown on the TV screen 5Still Mode5Switching Each Mode SAP 5Switching Audio ModeThis section describes how to switch the audio language StereoDay of Memories 5Screen InformationPress Info Broadcasting Information5TV Screen Display Mode To Cancel the Sleep Timer 5Sleep TimerPress Sleep to set the sleep timer Channel l List Optional Setting5Channel List Channel you want to add, then press Enter 5Manual Register5Antenna Confirmation Use the Number buttons or CH K/L to select5Picture Adjustment Treble, Bass 5Sound AdjustmentYou can adjust treble, bass and surround SurroundClosed Caption Detailil 5DTV Closed CaptionDTV CC Use Cursor K/L to select DTV CC, then press EnterFont Size 5CC StyleFont Style Closed Captioning font style can be changed as belowBack Opacity Font ColorFont Opacity Back ColorMpaa RatingDpage TV RatingDpage New Password DpageEnter password ChipTo Set the Sub Ratings Association of AmericaUse Cursor K/L to select TV Rating, then press Category Rating Use Cursor K/L to select New Password, then press EnterChipip Enter password Confirm password TV-14Horizontal Position, Vertical Position 5PC SettingsClock, Phase Audio 5HDMI Audio5Troubleshooting Guide TroubleshootingEntered channel number Check the batteries of the remote controlRefer to IR Signal Check on Delayed behind the dialogueAtsc MaintenanceInformation Glossary5Cable Channel Designations 5General Specifications5Electrical Specification 5Other SpecificationsMemo Limited Warranty Manual del Usuario Introducción Importante para su SeguridadInterferencia DE RADIO-TELEVISIÓN PrecaucionesPara Evitar LOS Riesgos DE Descarga Eléctrica E Incendio 5Accesorios suministrados5Símbolos utilizados en este manual UbicaciónÍndice Características5Instalación de las pilas 5Función del mando a distancia5Panel trasero Conexión a caja de cable o caja de satélite Conexión5Conexión básica Conexión de cable de antenaConexión HDMI-DVI 5Conexión de dispositivo externoConexión Hdmi Conexión de cable de S-video Conexión de cable de vídeo en componentesAnalógica Conexión de vídeoConexión de salida de audio Digital Conexión de PC Esta operación tardará unos momentos 5Configuración inicialAjuste Inicial 5Exploración automática de canales 5Menú principalIdiomaI Presione Setup para salir5Selección de idioma Para utilizar los botones numéricos 5Ajuste de volumenPara VER LA Televisión 5Selección de canalAl presionar CH L cambia el modo en sentido contrario 5Modo fijo5Para cambiar entre cada modo Emite audio en estéreo 5Para cambiar el modo de audioEn esta sección se describe cómo cambiar el idioma de audio EstéreoUn día ía de recuerdos 5Información de pantallaPresione Info Información de emisión5Modo de visualización de pantalla del televisor Presione Sleep para ajustar el temporizador de apagado 5Temporizador de apagadoLista Canales l Ajuste Opcional5Lista de canales La intensidad de la señal 5Registro manual 5Confirmación de la antenaDe la recepción en el ajuste inicial Utilice los botones numéricos o CH K/L para5Ajuste de imagen Agudo, Grave 5Ajuste de sonidoPuede ajustar el treble, el bajo y el sonido surround Haga el ajuste del sonido5Subtítulos cerrados Cerrados DTV deseados, y luego presione Enter 5Subtítulos cerrados en DTVPara seleccionar los subtítulos Tamaño Fuente 5Estilo CCEstilo Fuente Opaco Atrás Color FuenteTipo Borde Color FondoConsulte la siguiente descripción para ajustar cada elemento NC-17 No apto para menores de 17 años Para ajustar las subcategoríasCategoría Exclusivamente para público adultoClasificación Nueva Código de AccesoUtilice Cursor s/B para hacer ajustar el Reloj y 5Ajustes PCAjuste Automático Se ajustan automáticamente la posición Horizontal5Audio Hdmi 5Guía de solución de problemas Solución DE ProblemasDe infrarrojos El número de canalIntroducido cambia DistanciaMantenimiento InformaciónGlosario 5Otras especificaciones 5Denominaciones de canales de cable5Especificaciones generales 5Especificación eléctricaMemo Garantía Limitada