JVC AV-27WF36, V-32WF36, AV-27SF36, AV-32SF36, AV-27CF36, AV-32CF36 manual Service

Page 5

PORTABLE CART WARNING (Symbol provided by RETAC)

13For added protection of the TV set during a lightning storm or when the TV set is to be left unattended for an extended period of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to product due to lightning storms or power line surges.

14A TV set and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the TV set and cart combination to overturn.

Service

15Unplug this TV set from the wall outlet and refer servicing to qualified service personnel under the following conditions:

A.When the power cord or plug is damaged or frayed.

B.If liquid has been spilled into the TV set.

C.If the TV set has been exposed to rain or water.

D.If the TV set does not operate normally by following the operating instructions. Adjust only those controls that are covered in the operating instructions as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV set to normal operation.

E.If the TV set has been dropped or damaged in any way.

F.When the TV set exhibits a distinct change in performance — this indicates a need for service.

16Do not attempt to service this TV set yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

17When replacement parts are required, have the service technician verify in writing that the replacement parts he uses have the same safety characteristics as the original parts. Use of manufacturer’s specified replacement parts can prevent fire, shock, or other hazards.

18Upon completion of any service or repairs to this TV set, please ask the service technician to perform the safety check described in the manufacturer’s service literature.

19When a TV set reaches the end of its useful life, improper disposal could result in a picture tube implosion. Ask a qualified service technician to dispose of the TV set.

20Note to CATV system installer.

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

How to use the remote.

Before using, insert the lithium battery – CR2032 – correctly, with the plus (+) side up into the battery compartment. To open it, press the release tab and carefully pull the compartment out. The remote control can operate most of your TV’s functions, as well as basic functions of JVC VCRs.

*Point the remote towards the remote sensor on the target component. The maximum operating distance is about 8 meters.

*To operate a JVC VCR, use any of the following buttons:

VCR POWER, TV/VCR INPUT, VCR CH+/-, PLAY, REWIND, FAST-FORWARD, STOP, RECORD and PAUSE.

NOTE: If the remote does not work properly, remove the battery, wait for a few seconds, replace the battery and try again.

 

 

IN

CHINA

BATTERY

 

2

 

 

 

 

M

ADE

 

 

LITHIUMINSIDE

 

MANUAL

 

 

 

1

SEE

 

 

 

 

 

 

CR2025

5

Image 5
Contents Model Number Serial Number AV-27WF36 AV-32WF36 AV-27SF36 AV-32SF36 AV-27CF36 AV-32CF36Important Note Risk of Electrical Shock Do not Open Important Safety PrecautionsPlease read and retain for your safety Important SafeguardsFatal UsePortable Cart Warning Symbol provided by Retac ServiceTable of Contents Coaxial Cables Quick Setup Unpacking Your TVVideo Cable Component Cables Composite Cables Audio CablesFront Panel Diagrams Quick Setup TV ModelsRear Panel Diagrams AV-27WF36 AV-32WF36 AV-27SF36 AV-32SF36 AV-27CF36 AV-32CF36 Quick Setup TV Remote ControlRM-C203G Key Feature Buttons Quick Setup Getting StartedRemote Control Basic OperationConnecting Your Devices Quick Setup ConnectionsYes NoYes Diagram #2 Diagram #1 Diagram #3 Diagram #1 YesIllustration of AV-32WF36 Diagram #1Diagram #3 Connecting to an External Amplifier Connecting to a CamcorderLanguage Quick Setup Plug-In MenuTo be Interactive Plug In MenuManual Clock Set Auto Clock SetProgramming will take approximately 1 to 2 minutes Auto Tuner SetupAV-27WF36, AV-32WF36, AV-27SF36 and AV-32SF36 only Using the GuideOnscreen Menus XDS ID AV-27WF36, AV-32WF36, AV-27SF36 and AV-32SF36 only Onscreen Menu SystemChannel Summary Initial SetupAuto Tuner Setup Chip Channel Guard MessageDirections to Block Unrated Programs Unrated ProgramsUS V-Chip Ratings Directions to set US V-Chip Ratings Setting US V-Chip RatingsDirections to set Movie Mpaa Ratings Movies RatingsDirections to set Canadian V-Chip Ratings Canadian V-Chip RatingsSet Lock Code Closed Caption LanguageAuto Shut Off Front Panel LockVideo Input Label Adjust the Picture Settings Picture AdjustPicture Settings VSM Velocity Scan Modulation Color TemperatureNoise Muting Sound Settings Sound AdjustAdjust the Sound Settings MTS Multi-Channel Television SoundSet Clock Clock/TimersOn/Off Timer World Clock Button Functions Input Return +Sleep Sleep Timer MessageDisplay VCR Buttons Video StatusGame Problems Check TroubleshootingPage Page Model Specifications