Troubleshooting
Specifications
If a problem occurs when you are using the TV, check the below trouble- shooting guide before calling for repair.
TV RF systems
Others models : B, G, I, D, K, M
Problem
No or poor picture
Snowy picture
Stripes or coloured patches appeared
Cause / Solution
• Turn OFF BLUE BACK if it is ON. (\ page 5) |
• Adjust the COLOUR or BRIGHT setting. Refer to |
“PICTURE SETTING”. (\ page 5) |
• Choose the appropriate colour system. (\ page 5) |
• Check the aerial and TV connections. (\ page 3) |
• Interference caused by electrical appliances or |
speakers. Move them away from the TV. |
Colour systems
Receiving channels
(in VIDEO mode only)
Others models : PAL, SECAM, NTSC 3.58 MHz / NTSC 4.43 MHz
VHF low channel (VL), VHF high channel (VH), UHF channel (U) Receives cable channels in mid band, super band and hyper band.
No or poor sound
White and bright still image looks as if it is coloured
Image from video input is distorted
Cannot operate the remote control
Cannot operate the
MENU
Cannot operate the front panel buttons
Image takes a while to be displayed
TV emits crackling sound
Static shock when touch the TV screen
The TV turns off suddenly
• Interference caused by signal reflecting from mountains |
or buildings. Adjust the aerial’s direction or use another |
antenna. |
• Choose the appropriate sound system. (\ page 5) |
• Inevitable phenomenon due to the nature of the picture |
tube. This is not a malfunction. |
• The image was not properly recorded. This is not a |
malfunction. |
• Replace the batteries. (\ page 2) |
• Operate it at less than 7 meters from the TV. |
• Exit and enter the MENU again. |
• Turn OFF CHILD LOCK if it is ON. |
• Image requires time to stabilize before display. |
This is not a malfunction. |
• Caused by a sudden change in temperature and it is not |
a malfunction. Call a service technician for inspection. |
• Caused by static electricity of the picture tube and it will |
not harm the human body. This is not a malfunction. |
• This is not a malfunction. If you had set the BLUE |
BACK function to ON, TV will be turned off automatically |
when no signals are received from an antenna for about |
15 minutes or longer. |
Power requirements | ||
For Malaysia / | AC 160 to 240 V, 50 Hz / 60 Hz | |
Australia | ||
| ||
For others | AC 110 to 240 V, 50 Hz / 60 Hz | |
External input / output | ||
INPUT | VIDEO input, AUDIO input | |
OUTPUT | VIDEO output, AUDIO output | |
Headphone jack | Stereo mini jack (3.5 mm diameter) | |
Design and specifications are subject to change without notice.
© 2007 Victor Company of Japan, Limited |