-You can connect additional equipment, such as VCRs, camcorders etc. to your set. However please check with your manufacturers instruction books for specific information. Make sure all connections are made with both your set and additional appliance unplugged from the mains to avoid damaging your equipment. Here shown may be somewhat dif- ferent from your set.
1
Connect to Aerial socket
< Back panel of the set >
VCR
Connect the RF out socket of the VCR to the aerial socket on the back of the set.
Connect the aerial cable to the RF aerial in socket of the VCR.
Store the VCR channel on a desired programme number using the ‘Manual programme tuning’ sec- tion.
Select the programme number where the VCR channel is stored.
Press the PLAY button on the VCR.
2
Watching VCR
|
| < Back panel of the set > |
R AUDIO L VIDEO | R AUDIO L VIDEO | |
AV1 | AV2 |
|
(R) AUDIO (L) | VIDEO |
IN
<Back panel of VCR >
-If you connect an
-To avoid picture noise (interference), leave an adequate dis- tance between the VCR and set.
Use the INPUT SELECT button on the remote control to select AV1 or AV2.
(If connected to
Insert a video tape into the VCR and press the PLAY button on the VCR. (See VCR owner’s manual)
8