VMA5092
WIRING PRECAUTIONS
Read all wiring precautions. If you are not sure of the connections, contact your authorized Clarion dealer.
1.Disconnect the negative
2.When creating passage holes for the power wires, use grommets to elimi- nate any sharp edges created during drilling. This will protect the wire from being nicked and causing a short circuit.
3.When connecting the ground lead, fasten the ground lead (black) securely to a clean metal plate on the vehicle.
NOTE: The VMA5092 monitor displays video images only. It does not provide audio output. Refer to the owner's manual of the connected device for informa- tion on audio output.
INSTALLATION
The VMA5092 is a 5" monitor with an Infrared (IR) eye. It will accept a video signal from any video source with composite video out. The IR eye will work directly with any Clarion video source product with an IR Eye Input.
1.Install Mounting Bezel in vehicle headrest.
2.Once a location has been determined, connect the IR, Video RCAs and power cables to the designated sources.
3.Feed the cables through the mounting location.
4.Plug the cable into the monitor's 8 Pin Din connector. Mount the monitor in the designated mounting bezel.
8 Pin Mini DIN Connector
1DC 12V
2IR Out
3 | Ground |
4 | Video Input |
5 | A/V Signal Ground |
6 | NC |
7 | NC |
8 | NC |
VIDEO IN
50CM 2PIN POWER CABLE
| NAX9500E |
| 3.5mm IR REMOTE CABLE IR REMOTE |
VS718 | OUT |
|
3