Sceptre Technologies x32 user manual Connecting to a PC with VGA and 3.5 mm minijack …

Connecting to a PC with VGA and 3.5 mm minijack …

1.Make sure the power of HDTV and your PC is turned off.

2.Obtain a 15-pin D-Sub VGA cable; connect to the VGA output of your PC and the other end to the VGA port on the back of your HDTV.

3.Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the other end to the VGA Stereo Input port.

4.Turn on the power of the HDTV and your PC.

5.Use the remote control’s source button or the source button on the TV to switch to

VGA.

6.Change your PC resolution to panel native resolution for better performance.

7.Press MENU to use the OSD’s SETUP option.

8.Under the SETUP option select PC function.

9.Under VGA function use AUTO ADJUST to adjust the screen.

Please Note :

∙For the best results, please set your PC resolution to 1920x1080 at 60

Hz. Please refer to the PC or graphic card’s manual for further instructions on how to set your resolution and refresh rate.

∙Please refer to your PC manual for video output requirements of the video card.

∙The VGA port of the TV features a power saving mode which will automatically turn off the TV, if there’s no signal provided for more than 5 minutes.

- 22 -

www.SCEPTRE.com

SCEPTRE X32 HDTV User Manual