Introduction, Front View | ProScan PLCD5085A specification

Introduction

1. Front View

Power Indicator

Remote Control window (Keep clear)

1). (IR) Infrared Receiver: Receives IR signals from the remote control. (Power on/Standby)LED Indicator: Press POWER to turn on and off.

Indicator on(Red)	Standby mode
Indicator on(Green)	Power on mode

The effective receiving range for the signal is 5-8 metres from the front of the remote control window, and 300 to the left or right side and 200 above or below the remote control window.

2). The functions of the buttons:

INPUT: Press to display the input source menu.

MENU: Press to display the OSD menu, press again to exit the menu.

CH^/v:Press to scan through channels.

VOL+/-:Press to adjust the volume.

POWER: Turn on/standby the TV set.

Press INPUT button on the TV set or remote control to display the input source menu, and use CH+/- button on the TV set or / button on remote control to select the input source, press OK button on the remote control to enter.

Note: Before you select the input source, make sure the connections are prepared.