Sceptre Technologies E55 user manual Troubleshooting

Troubleshooting

The following table contains the common problems and the solutions to these problems. Please check this list before you contact the technicians.

Problems	Solutions
	Connect power cord correctly.
	Turn on power.
NO PICTURE	Connect video cable correctly.
	Select the input signal source with proper cable connection with
	the source button.
ABNORMAL	Match the colors on the cables to the ports off the back of the
COLORS	television. I.E. red cable to red colored port.
PICTURE IS TOO	Adjust your contrast, brightness and lamp settings from the
DARK	OSD Menu. For adjust controls, refer to page 27.
AUDIO ONLY NO	Make sure you have connected both your video and audio
	cables.
PICTURE
	The TV’s tuner signal must not be lower than 65 %.
	Make sure the audio cable is connected.
PICTURE ONLY NO
	Readjust your volume via the remote control.
AUDIO
	The TV’s tuner signal must not be lower than 65 %.
	Turn off the TV, unplug it from the socket. Remove the
	batteries out of the remote for 30 seconds. Press the remote
	buttons and the power button randomly for a good 2 seconds,
REMOTE CONTROL	and then reinstall the batteries. Try the remote to see if it
	works. For battery removal instructions, refer to page 16.
DOES NOT WORK
	The TV’s remote sensor is also housed in the same place as
	the power indicator light. Please make sure there is line of sight
	from the remote control’s front sensor to the remote sensor of
	the TV.
CANNOT RECEIVE	The TV’s tuner signal must not be lower than 65 %. Change
SUFFICIENT	the direction of your antenna and rescan your channels. If you
CHANNELS	have cable call up your cable company and ask about signal
THROUGH THE	strength of your local cable.
ATSC/NTSC TUNER
	Please adjust your picture setup and make sure the saturation
NO COLOR	and the RGB are not turned all the way down. For adjustment
	controls refer to page 27.

- 47 -

www.SCEPTRE.com

SCEPTRE E55 HDTV User Manual