Troubleshooting
The following table contains the common problems and the solutions to these problems. Please check this list before you contact the technicians.
| Problems | Solutions |
|
| Connect power cord correctly. |
| NO PICTURE | Turn on power. |
| Connect video cable correctly. | |
|
| Select the input signal source with proper cable connection with |
|
| the source button. |
| ABNORMAL | Match the colors on the cables to the ports off the back of the |
| COLORS | television. I.E. red cable to red colored port. |
| PICTURE IS TOO | Adjust your contrast, brightness and lamp settings from the |
| DARK | OSD Menu. For adjust controls, refer to page 25. |
| AUDIO ONLY NO | Make sure you have connected both your video and audio |
| PICTURE | cables. |
|
| The TV’s tuner signal must not be lower than 65 %. |
| PICTURE ONLY NO | Make sure the audio cable is connected. |
| AUDIO | Readjust your volume via the remote control. |
|
| The TV’s tuner signal must not be lower than 65 %. |
|
| Turn off the TV, unplug it from the socket. Remove the |
|
| batteries out of the remote for 30 seconds. Press the remote |
| REMOTE CONTROL | buttons and the power button randomly for a good 2 seconds, |
| DOES NOT WORK | and then reinstall the batteries. Try the remote to see if it |
|
| works. For battery removal instructions, refer to page 13. |
|
| The TV’s remote sensor is also housed in the same place as |
|
| the power indicator light. Please make sure there is line of sight |
|
| from the remote control’s front sensor to the remote sensor of |
|
| the TV. |
| CANNOT RECEIVE | The TV’s tuner signal must not be lower than 65 %. Change |
| SUFFICIENT | the direction of your antenna and rescan your channels. If you |
| CHANNELS | have cable call up your cable company and ask about signal |
| THROUGH THE | strength of your local cable. |
| ATSC/NTSC TUNER |
|
|
| Please adjust your picture setup and make sure the saturation |
| NO COLOR | and the RGB are not turned all the way down. For adjustment |
|
| controls refer to page 25. |
|
| The TV’s tuner signal must not be lower than 65 %. Check your |
|
| signal. |
| WEAK SIGNAL OR | The TV’s tuner signal must not be lower than 65 %. Change |
| NO PROGRAM | the direction of your antenna and rescan your channels. If you |
| SYMBOL ON | have cable calls up your cable company and ask about signal |
| SCREEN | strength of your local cable. |
| TV’S UNIVERSAL | This television follows SONY’s universal remote code. To find |
| REMOTE CODE | the actual code you must read through your own universal |
|
| remote’s guide book. |
- 47 -
www.SCEPTRE.com
SCEPTRE E195 Series LED HDTV User Manual