First installation
If the reception conditions are good, then a room antenna may be used for
It may be practical to use a nondirectional antenna. If the location is outside the normal transmitting range, then a unidirectional antenna may also be used to improve the reception quality.
You can find out more on the digital stations that can be received in your area at your specialist dealer.
If a Xelos A32/37/42 was retrofitted with a PIP tuner or if this is already integrated in a set with a digital recorder, then plug the antenna into the antenna input of the PIP tuner and connect the PIP tuner output with the
If a Digital Satellite Tuner 1 has been retrofitted, connect your satellite antenna system to the
Using the common interface module
(only for sets with CI slot)
In order to be able to receive encrypted digital stations, the common interface module (CI module) and the smartcard both have to be inserted into the corresponding slot of your TV set. You can purchase the CI module and smartcard at your specialist dealer. You can find the slot on the back of your TV set, see the illustrations on pages 6 – 8.
1.Make sure the TV set is switched off with the mains switch on the set, or pull the mains plugs.
2.First push the smartcard into the CI module as far as it will go. Insert it so that the side with the golden contact chip faces the side of the module printed with
the supplier‘s brand logo. Printed arrows indicate how to insert the card. Also follow the installation instructions included with the smartcard.
If a Digital Satellite Tuner 2 has been retrofitted (only in conjunction with the Digital Recorder+), then connect one antenna cable each, for example from the antenna switch or from the twin LNC, to both SAT sockets.
When laying the cable, use the cable clips affixed beneath the TV set. Replace the connection cover on the TV set.
Handling the fabric hose
Use the fabric hose included with Xelos A 32/37/42 to lay the mains cables, antenna cables or cables from other electronic components systematically; then lead the
3.Slide the CI module ✳ carefully into the slot with the contact side facing the front. The logo on the common interface module should be visible.
Make sure the module is not twisted in the process. Do not use force.
When the module locks, the eject button is pressed outwards.
✳The CI module and the smartcard are not included in the scope of delivery for this set; you can usually obtain them at your specialist dealer.
Switching on
Press the mains switch (for Xelos A 32/37, the set switches on immediately, the green indicator lamp lights up).
Eject button
CI module
COMMON INTERFACE
hose with the cables to the connection boxes. This provides you with an elegant solution when laying cables.
The diameter of the fabric hose increases when you push it together lengthwise (see illustration). This makes it easier for you to push through cables with plugs.
For Xelos A 26/42:
The red indicator on the set now lights up (standby mode).
Switch on the set using the switch integrated in the indicator.
After switching on, it takes about 2 minutes for the screen to reach full brightness due to the LCD technology.
13