Connecting your TV
Connecting the audiovisual equipment
To enjoy the programs coming from your audiovisual equipment such as VCR, DVD, Satellite receiver, Camcorder, Audio amplifier etc, the signal must be received by the set via the AV input terminals at rear. Connect the devices as the shown below.
Note: When connecting YUV (Y Cb Cr) jacks, Audio Left and Right cables should be connected to AUDIO
INPUT terminals.
TV |
|
|
| IN |
|
Y | VIDEO |
|
Cb | AUDIO | ANT75 |
Cr | MONO |
|
|
|
VCR/DVD
PLAY VIDEO TAPE, DVD etc.
OUTPUT
Y Cb Cr
VCR/DVD
OUTPUT
VIDEO LEFT(MONO) RIGHT
To the input terminals
Connecting the antenna
To enjoy the signal transmitted by your local TV station, you need an indoor or outdoor antenna ( not supplied ). Perfect picture quality requires a good signal and generally means that an outdoor antenna must be implemented. The exact type and location of the antenna will depend on your particular area. Consult your local dealer or service personnel for best advice. If you are a subscriber of your local CATV net, the outdoor or indoor antenna is not needed. Connect the equipments as the following figure.
Plug(not supplied)
Rear View
Coaxial Cable (75Ω )
IN
Y
VIDEO
Cb
AUDIO
MONO
Cr
Antenna Socket | ||
| Adaptor (not supplied) |
|
| Loosen the screw | Insert the feeder in |
The signal comes from: An outdoor antenna An indoor antenna CATV net
Tighten the screw