Tuning the TV to Your VCR
The VCR supplies a signal to the TV via the RF coaxial cable on channel
It is possible to view the video picture on your TV in the same way that you watch TV broadcasts.
If you have connected the VCR to the TV through the Audio/ Video input sockets, then you do not need to follow the procedure below.
Preparation
≥Turn on the TV and the VCR.
Operation
1 Hold down the MENU button V for 5 seconds or more.
2 Set theTV to an unused position which you wish to use for your video playback.
≥Tune the TV until the display
shown on the right appears on | Panasonic VCR | |||||||
the screen. (Please refer to the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
TV manufacturers operating |
|
|
|
|
|
|
|
|
RF SELECT |
|
|
| BG I ≥DK | ||||
instructions regarding tuning.) | RF SELECT: |
|
|
| END:MENU | |||
|
| |||||||
|
|
|
|
|
|
|
| |
3 Press the MENU button V.
To Change the RF output Channel
In some rare cases after tuning the TV to your VCR, interference may be visible on the picture. To get rid of this interference, you can manually adjust the RF output channel a few channels up and down from the current setting. The procedure is described below.
Operations
1Hold down the MENU button V for 5 seconds or more.
≥The VCR display changes as shown below and the VCR picture on the TV displays this pattern.
VCR display
Panasonic VCR
RF SELECT BG I ≥DK
RF SELECT: 
END:MENU
2Enter the desired channel number
≥Ensure that the VCR/TV switch R is set to “VCR”.
≥Set the RF output channel of the VCR to “ss” (RF OFF) when the VCR is connected to the TV via the Audio/ Video cable.
Press the Channel button P to display “ss”.
For New Zealand |
|
| For Australia | |
21E | … 69E | 28 | … | 37 … 69 |
(Initial position)
(RF OFF)
≥It is also possible to select by pressing the Numeric buttons 2 (only for Australia).
Example:
28:
2 
8
3Press the MENU button V to finish the setting mode.
4Retune your TV to the new RF channel for the VCR. (Refer to the operations on the left.)
8