Side Bar
Do not display a picture in 4:3 mode for an extended period, as this can cause “Image |
| Side Bar |
| Image retention |
retention” to remain on either or both sides of the display field. |
|
|
|
|
To reduce the risk of such “Image retention”, change the brightness of the side bars. |
| 4:3 |
|
|
The side bar may flash (alternate black/white) depending on the picture. Using |
| Screen |
|
|
•Studio ref mode will reduce such flashing (See p. 56). |
| Display |
|
|
•TV screen (RF input) cannot be displayed in both main and split frame simultaneously.
•The
Input signal that can be displayed
* Mark: Applicable input signal for Component (Y, PB, PR), HDMI and PC
|
|
| horizontal frequency (kHz) | vertical frequency (Hz) |
| COMPONENT |
| HDMI | PC |
525 | (480) / 60i |
| 59.94 |
| * |
| * |
| |
15.73 |
|
|
| ||||||
525 | (480) /60p | 31.47 | 59.94 |
| * |
| * |
| |
750 | (720) /60p | 45.00 | 59.94 |
| * |
| * |
| |
1,125 | (1,080) /60i | 33.75 | 59.94 |
| * |
| * |
| |
1,125 | (1,080) /60p | 67.43 | 59.94 |
|
|
| * |
| |
1,125 | (1,080) /60p | 67.50 | 60.00 |
|
|
| * |
| |
640 | × 400 @70 | 31.47 | 70.08 |
|
|
|
| * | |
640 | × 480 @60 | 31.47 | 59.94 |
|
|
|
| * | |
Macintosh13” (640 × 480) | 35.00 | 66.67 |
|
|
|
| * | ||
640 | × 480 @75 | 37.50 | 75.00 |
|
|
|
| * | |
852 | × 480 @60 | 31.47 | 59.94 |
|
|
|
| * | |
800 | × 600 @60 | 37.88 | 60.32 |
|
|
|
| * | |
800 | × 600 @75 | 46.88 | 75.00 |
|
|
|
| * | |
800 | × 600 @85 | 53.67 | 85.08 |
|
|
|
| * | |
Macintosh16” (832 × 624) | 49.73 | 74.55 |
|
|
|
| * | ||
1,024 | × 768 @60 | 48.36 | 60.00 |
|
|
|
| * | |
1,024 | × 768 @70 | 56.48 | 70.07 |
|
|
|
| * | |
1,024 | × 768 @75 | 60.02 | 75.03 |
|
|
|
| * | |
1,024 | × 768 @85 | 68.68 | 85.00 |
|
|
|
| * | |
Macintosh 21” (1,152 × 870) | 68.68 | 75.06 |
|
|
|
| * | ||
1,280 | × 1,024 @60 | 63.98 | 60.02 |
|
|
|
| * | |
1,366 | × 768 @60 | 48.36 | 60.00 |
|
|
|
| * | |
Note
•Signals other than above may not be displayed properly.
•The above signals are reformatted for optimal viewing on your display.
•Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
•Some PC models cannot be connected to the set.
•There is no need to use an adapter for computers with IBM PC/AT compatible
•The maximum resolution: 1,280 × 1,024
If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
•Signal Names for
|
|
|
| Pin No. | Signal Name | Pin No. | Signal Name | Pin No. | Signal Name |
11 | 12 | 13 | 14 | 15 | R | 6 | GND (Ground) | 11 | NC (not connected) |
6 | 7 | 8 | 9 10 | G | 7 | GND (Ground) | 12 | NC | |
1 | 2 | 3 | 4 | 5 | B | 8 | GND (Ground) | 13 | HD/SYNC |
|
|
|
|
| NC (not connected) | 9 | NC (not connected) | 14 | VD |
Pin Layout for PC Input Terminal 5 | GND (Ground) | 10 | GND (Ground) | 15 | NC | ||||
Technical Information FAQs, etc.
57