M-Audio Delta 44 specifications Hardware Installation

Page 5

2.Start Windows and allow Windows’ Plug-and-Play to prompt you for the Delta 44 drivers via the Add New Hardware wizard. Install drivers and support software (see ‘Windows Software Installation’).

3.On the Mac, drag the Delta extension to the Extensions folder, and the appropriate ASIO driver to your application’s ASIO folder. Restart. If not using ASIO, set the Sound Manager to Delta (see Mac Installation).

4.Configure your digital recording software to use the Delta 44 as its active audio device (see ‘Using the Delta 44 with your Software Application’ and also your software application’s manual).

5.Hook up your digital and analog audio gear (see ‘Delta 44 Recording Tutorials’). Configure your Delta Control Panel software for proper monitoring and playback.

Hardware Installation

To mechanically install the Delta 44, do the following:

1.Turn off your computer.

2.Remove the computer’s cover and position the computer so that you may easily access its PCI slots.

3.Select the PCI slot where you will install your Delta 44 PCI host card. Make sure the slot is a PCI slot. If you don’t know what “PCI slot” means, check the owner’s manual for your computer. PCI slots are distinguishable from ISA slots by being shorter and set back farther from the outside of the computer, however some newer computers have only PCI slots.

4.Before removing the Delta 44 PCI host card from its protective anti-static bag, touch the metal power supply case of the computer in order to dissipate any static electricity your body may have accumulated. You might want to pick up a grounding wrist strap (available from electronics stores like Radio Shack) if you want to be doubly sure you aren’t carrying a static charge that could damage the card.

5.Remove the metal bracket that covers the access hole on the back of the computer. This bracket is usually fastened to the computer with a single screw.

6.Position the Delta 44 PCI host card over the target PCI slot and fit the card loosely over it with the card in the upright position. Press the card gently but firmly downward into the slot until the card is completely and squarely seated in the slot. If the card seems difficult to seat, a slight rocking motion may help.

7.Screw the Delta 44 PCI host card’s metal bracket down into the screw hole on the back of your computer using the screw you removed in step 5 above.

8.Place the cover back on your computer.

Now it is time to connect the Delta 44 break-out box to the PCI host card that you have just installed. Never attach the break-out box with the computer turned on. Doing so could damage the PCI card, and void your warranty.

5

Image 5
Contents Delta 44 Manual Table of ContentsAbout the Delta 44 Digital Recording Interface IntroductionWhat’s in the Box? Minimum System Requirements Product Features & SpecificationsBreak-Out Box Front Panel Quick Guide to Getting StartedBreak-Out Box Back Panel PCI Host Adapter CardHardware Installation Windows 98 Installation Delta Driver & Software InstallationWindows NT 4.0 Installation Windows 95 InstallationMacintosh Installation Windows NT 3.51 InstallationVerifying Windows Driver Installation Delta’s Analog Input/Outputs Verifying Delta Control Panel Software InstallationDelta System Overview Patchbay / Router Digital Monitor MixerSynchronization Using the Delta 44 with your Software ApplicationPage Delta 44 Control Panel Software Monitor Mixer Page Patchbay/Router Page Hardware Settings Page About PdifSave, Delete, Load Buttons H/W Installed Delta 44 Recording Tutorials Typical Setup #1Page Page Page Page Page Typical Setup #2 Page Page Troubleshooting Page Page Problem No Sound Troubleshooting Tips for Frequently Asked QuestionsAdapter Resource Requirements Appendix a Technical SpecsAnalog Audio Appendix B -If You Use An External Mixer Page Limited Lifetime Warranty