Furuno MU-170C manual Changing the signal name, Signal name area

3.3.2Changing the signal name

You can change the signal name which is shown on the DISP selection window (page 16) and PIP selection window (page 17). It is useful to use the name of the device connected (ex. “FCV-1200L”).

1.Press the MENU key to show the main menu.

2.Press the ◄ or ► key to select OSD.

Signal name area

RGB1 RGB2 DVI VIDEO1 VIDEO2 VIDEO3 OSD SYSTEM

H_POSITION		15	(1 – 29)
V_POSITION		37	(1 – 37)
TRANSLUCENT		OFF	(OFF/ON)
PIP SW TIME		OFF	(OFF, 5-20)
PIP SKIP		OFF	(OFF, V1/V2/V3)
CUSTOM NAME
RGB1	= RGB1______
RGB2	= RGB2______
DVI	= DVI_______
VIDEO1	= VIDEO1____
VIDEO2	= VIDEO2____
VIDEO3	= VIDEO3____

OSD menu

3.Press the ▲ or ▼ key to select the signal to change its name in the signal name area. In the example above, RGB1 is chosen.

4.Press the ► key to select the character you want to change. In the example below, “G”

of RGB1 is selected.

CUSTOM NAME

RGB1	= RGB1______
RGB2	= RGB2______
DVI	= DVI________
VIDEO1	= VIDEO1____
VIDEO2	= VIDEO2____
VIDEO3	= VIDEO3____

5.Press the ▲ or ▼ key to select appropriate alphanumeric character. In the example below, “5” is selected.

You can set up to ten characters. “A to Z”, “0 to 9”, “-”, “.”, “ ” (space) are available.

CUSTOM NAME

RGB1	= R5B1______
RGB2	= RGB2______
DVI	= DVI________
VIDEO1	= VIDEO1____
VIDEO2	= VIDEO2____
VIDEO3	= VIDEO3____

6.To change another signal name, press the ◄ key several times to return the cursor to the signal name area and then press the ▲ or ▼ key to select signal name.

7.Press the MENU key to close the menu.

11