Hitachi VTFX695A Precautions, Channel, Front Panel, Rear Panel, To insert the batteries

	PRECAUTIONS
OF CONTROLS	DESCRIPTION

PRECAUTIONS

INSTALL LOCATION

For safety and optimum performance of your VCR:

•Install the VCR in a horizontal and stable position.

•Do not place anything directly on top of the VCR.

•Do not place the VCR directly on top of the TV.

•Shield it from direct sunlight and keep it away from sources of intense heat. Avoid dusty or humid places.

•Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes on the sides of the VCR. Avoid locations subject to strong vibration or strong magnetic fields.

AVOID THE HAZARDS OF

ELECTRICAL SHOCK AND FIRE

•Do not handle the power cord with wet hands.

•Do not pull on the power cord when disconnecting it from AC wall outlet. Grasp it by the plug.

•If, by accident, water is spilled on your VCR, unplug the power cord immediately and take the unit to our Authorized Service Center for servicing.

•Do not put your fingers or objects into the VCR cassette holder.

MOISTURE CONDENSATION WARNING

Moisture condensation may occur inside the unit when it is moved from a cold place to a warm place, or after heating a cold room or under conditions of high humidity. Do not use the VCR at least for 2 hours until its inside is dry.

FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized recording or use of broadcast television programming, video tape, film or other copyrighted material may violate applicable copyright laws. We assume no responsibility for the unauthorized duplication, use, or other acts which infringe upon the rights of copyright owners.

A NOTE ABOUT RECYCLING

This product's packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations. Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

Note to the Cable TV System Installer:

This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding – in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION:

POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

DESCRIPTION OF CONTROLS

Front Panel
					1		2	3	4	5
								STOP/EJECT	PLAY
							REC/IRT	REW	F.FWD
	VIDEO-IN L AUDIO-IN R		POWER			CHANNEL
						TRACKING
	12	11	10	9	8	7	6
1. Cassette Compartment						7. CHANNEL (			)	button
2. REW button						8. Display Window
3. STOP/EJECT button						9. Remote Sensor
4. PLAY button					10. POWER button
5. F.FWD button					11. AUDIO Input jacks
6. REC/IRT button					12. VIDEO Input jack
Display Window			13				16
			14				17
			15				18
13. PWR. indicator					16. REC indicator
14. TAPE IN indicator					17. TIMER indicator
15. VCR indicator					18. CLOCK indicator
Rear Panel
	19						20	21 22
							AUDIO		ANT
							L		IN
							OUT	IN
							R
							VIDEO		OUT
							OUT	INCH3 CH4
							23 24 25 26
19. AC Power Cord					23. VIDEO OUT jack
20. AUDIO OUT jacks					24. VIDEO IN jack
21. AUDIO IN jacks					25. CH3/CH4 selector switch
22. ANT. IN jack					26. ANT. OUT jack
Remote Control						1. POWER button
						2. NUMBER buttons
						3. TAPE SPEED button
					9	4. MENU button
						5. DISPLAY button
1	POWER	VCR	TV	CATV
						6. REW button
				VCR/TV	10
	1	2	3			7. STOP button
2					11
	4	5	6	CH		8. REC button
	7	8	9			9. MODE SELECT buttons
3	TAPE SPEED		ENTER			10. VCR/TV button
		0	+100		12
4	MENU	DISPLAY	MUTE	VOL		11. CH (	) button
5					13	12. VOL button
		PLAY			14
6	REW		F.FWD		15	13. MUTE button
7		STOP				14. PLAY button
					16
	REC		SLOW	PAUSE
8					17	15. F.FWD button

SEARCH MODE

1816. SLOW button

EXIT COUNTER

19 17. PAUSE/STILL button

RESET MEMORY

20 18. SEARCH MODE button

19. COUNTER/MEMORY button

20. EXIT/RESET button

To insert the batteries

Install two AA batteries matching the polarity indicated inside the battery compartment.

– 2 – EN