JVC LPT0724-001B, HR-J291EA How to use the remote control, Video heads cleaning, Usable cassettes

Page 2

The STANDBY/ON 1 button does not completely shut off mains power from the unit, but switches operating current on and off. “`” shows electrical power standby and “ ! ” shows ON.

Video tapes recorded with this video recorder in the LP (Long Play) mode cannot be played back on a single-speed video recorder.

When the equipment is installed in a cabinet or a shelf, make sure that it has sufficient space on all sides to allow for ventilation (10 cm or more on both sides, on top and at the rear).

When discarding batteries, environmental problems must be considered and the local rules or laws governing the disposal of these batteries must be followed strictly.

Failure to heed the following precautions may result in damage to the recorder, remote control or video cassette.

1.DO NOT place the recorder …

in an environment prone to extreme temperatures or humidity.

in direct sunlight.

in a dusty environment.

in an environment where strong magnetic fields are generated.

on a surface that is unstable or subject to vibration.

2.DO NOT block the recorder’s ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

3.DO NOT place heavy objects on the recorder or remote control.

4.DO NOT place anything which might spill on top of the recorder or remote control.

(If water or liquid is allowed to enter this equipment, fire or electric shock may be caused.)

5.DO NOT expose the apparatus to dripping or splashing.

6.DO NOT use this equipment in a bathroom or places with water. Also DO NOT place any containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) on top of this unit.

7.DO NOT place any naked flame sources, such as lighted candles, on the apparatus.

8.AVOID violent shocks to the recorder during transport.

MOISTURE CONDENSATION

Moisture in the air will condense on the recorder when you move it from a cold place to a warm place, or under extremely humid conditions—just as water droplets form on the surface of a glass filled with cold liquid. Moisture condensation on the head drum will cause damage to the tape. In conditions where condensation may occur, keep the recorder’s power turned on for a few hours to let the moisture dry.

How to use the remote control

Before use, insert the batteries in the correct directions as indicated under the battery cover. The remote control can operate most of your recorder’s functions, as well as basic functions of JVC TV sets.

Point the remote control toward the receiving window on the recorder.

The maximum operating distance of the remote control is about 7.5 m.

To operate your JVC TV, press the corresponding button: TV 1, TV AV, TV PR +/–, TV %+/– (TV Volume).

NOTE:

If the remote control does not work properly, remove its batteries, wait for a few seconds, replace the batteries and then try again.

Video heads cleaning

Accumulation of dirt and other particles on the video heads may cause the playback picture to become blurred or interrupted. Be sure to contact your nearest JVC dealer if such troubles occur.

Usable cassettes

Compact VHS camcorder recordings can be played on this recorder. Simply place the recorded cassette into a VHS Cassette Adapter and it can be used just like any full-sized VHS cassette.

This recorder can record on regular VHS and Super VHS cassettes. However, it will record and play back regular VHS signals only. It is not possible to play back a recorded Super VHS cassette.

ATTENTION:

To mobile phone users:

Using a mobile phone in the vicinity of the recorder may cause picture vibration on the TV screen or change the screen to a blue back display.

On placing the recorder:

Some TVs or other appliances generates strong magnetic fields. Do not place such appliance on top of the recorder as it may cause picture disturbance.

— 2 —

Image 2
Contents Safety Precautions HR-J695EA HR-J291EAUsable cassettes How to use the remote controlVideo heads cleaning To mobile phone usersFront Panel Buttons, ConnectorsIndicators Rear PanelOn-screen display Change settingAccess Main Menu screen Main MenuAV Connection Basic ConnectionsRF Connection Language Set Initial SettingsVideo Channel Set Clock Set Tuner Set Auto Channel SetChanging station channel positions Manual Channel SetDeleting a channel Changing station name aChanging station name B Fine-tuning channelsPerform tuning Select character for station nameBasic Playback Playback FeaturesPlayback Basic Recording Recording FeaturesRecording Memory Stop FacilityBefore starting Timer RecordingTimer Programming Cancel or change programme setting Checking, canceling or changing programme settingsDisengage timer recording standby mode Re-engage timer recording standby modeEditing Editing with another video recorder or a camcorderColour System Set Subsidiary SettingsSystem Connections Child LockSpecifications General