26
EN
EDITING
Edit To
Another Video
Recorder
PLAY
| TV Receiver | Source player |
| Your recorder | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
VIDEO | AV Cable | |
(not provided) | ||
CHANNEL | ||
| ||
RF Cable (provided) |
| |
| Another recorder |
You can use your video recorder as the source player and another video recorder as the recording deck.
| 1 |
| MAKE CONNECTIONS |
|
| Connect the player’s AUDIO/VIDEO OUT connectors | |
|
| to the recorder’s AUDIO/VIDEO IN connectors. | |
|
|
| SET RECORDING DECK’S |
| 2 |
| INPUT MODE |
|
| Set the recording deck's external input mode. | |
| 3 |
| START SOURCE PLAYER |
|
| Press PLAY on the source player. | |
| 4 |
| START RECORDING DECK |
|
| Engage its Record mode. |
NOTES:
●All necessary cables can be obtained from your dealer.
●If you do not want to record the superimposed indication on the editied tape, be sure to set "O.S.D." to "OFF" before you start editing (☞ pg. 9).
Recording deck
VCR
|
| 1 | 2 | 3 NUMBER "2" |
|
|
|
| 2 |
|
| 4 | 5 | 6 |
NUMBER | "1" | 7 | 8 | 9 |
| ||||
|
| 0 | 4 | |
|
|
|
1
STOP
Remote A/B Code Switching
The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.
1Unplug the mains power cord from the mains outlet.
2While holding down VCR on the remote control, press the NUMBER key "2" and then press STOP.
3Plug the mains power cord back into the mains outlet.
4Press 
on the remote control. The recorder will now only respond to B code signals.
NOTES:
●Some TV sets may malfunction in response to the B code. If this happens, switch back to the A code.
●To set the recorder back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key "1" instead of "2" in step 2.