SPECIALFEATURES
EN35
TV Multi-Brand Remote Control
The VCR's remote control can control several functions on JVC remote control TVs and on the brands of remote control TVs listed below. *The default setting is JVC code 01.
POWER
TV
1 2 3
TV/VCR
4 | 5 | 6 | NUMBER |
MBR SET
7 8 9
0
ENTER
CH
TV VOL +/–
1 3 Á
¦ 7 8
4 ¢
STOP
1
2
3
TURN ON THE TV
Turn the power on using the TV's remote control.
SET TV BRAND CODE
Refer to the chart below. While holding down TV on the VCR's remote control, press MBR SET and enter your TV’s brand code using the NUMBER keys, then press STOP. Follow the example shown at bottom left.
●Once you have set the remote control to operate the TV, you don’t have to repeat this step until you replace your remote control’s batteries.
●PANASONIC has two codes. If the TV does not function with one code, try entering the other.
OPERATE TV
First, while holding down TV, press POWER on the remote to see if the TV’s power goes off as it should. If it does, try other operations.
●The POWER, TV/VCR, CH5°, TV VOL +/– and NUMBER keys on the remote can all be used to operate the TV. *For some brands of TV, you must press ENTER after having pressed the NUMBER keys.
●To operate your TV, while holding down TV, press the corresponding button: POWER, TV/VCR, CH5°, NUMBER keys (or ENTER). TV VOL +/– can be used without holding down TV.
(Ex.) To set remote control to RCA 05:
TV | MBR SET 0 AUX | 5 | 7STOP |
|
|
| Release |
Hold | Press in succession |
| |
down |
|
|
|
NOTE:
Depending on the type of TV, there may be cases where some or all functions cannot be operated using the remote control.
TV BRAND NAME | BRAND CODE |
JVC | 01 |
MAGNAVOX | 02 |
MITSUBISHI | 03 |
PANASONIC | 04, 11 |
RCA | 05 |
SHARP | 06 |
SONY | 07 |
TOSHIBA | 08 |
ZENITH | 09 |
HITACHI | 10 |
SAMSUNG | 12 |
SANYO | 13 |
SEARS | 13 |
|
|