JVC HR-VP652U, HR-VP452U instruction manual Express Timer Programming, SET Program Date

34ENTIMERRECORDING(cont.)

Express Timer Programming

Turn on the TV and select the VCR channel 3 or 4 (or AV mode).

1 2 3

2

4 5 6

7 8 9

0 4

START+/–

PROG. 1

STOP+/– DATE+/–

You can directly program the VCR’s timer to record up to 8 shows, as far as a year in advance. Remember, the clock must be set before you can program the timer (☞ pg. 8 or 11).

1		LOAD A CASSETTE
	Make sure the record safety tab is intact. If not, cover
		the hole with adhesive tape, then load it into the VCR.
		● The VCR comes on, and the counter is reset,
		automatically.
		ACCESS VCR PLUS+
2		SCREEN
	Press PROG.
		ACCESS PROGRAM
3		SCREEN
	Press START +/–. (If you’re			PROGRAM 1
		just starting out,
				START		STOP
		“PROGRAM 1” appears.)
				– –:– –AM	=	– –:– –AM
				DATE		CH
				– –/– –/– –		– – –	SP
			PRESS (+/–, SP/EP, 8=DAILY,
			9=WEEKLY), THEN (0K)
			PRESS (PROG.) TO END
4		SET PROGRAM START TIME
	Press START +/– to enter			PROGRAM 1
		the time you want
				START		STOP
		recording to start.
				8:00 AM	=	– –:– –AM
		● Press and hold START		DATE		CH
				– –/– –/– –		– – –	SP
		+/– to move in 30-
		minute increments, or	PRESS (+/–, SP/EP, 8=DAILY,
		press and release	9=WEEKLY), THEN (0K)
			PRESS (PROG.) TO END
		repeatedly to move 1
		minute at a time.
5		SET PROGRAM STOP TIME
	Press STOP +/– to enter the time you want recording to
		stop.
		● Press and hold STOP +/– to move in 30-minute
		increments, or press and release repeatedly to move 1
		minute at a time.
6		SET PROGRAM DATE
	Press DATE +/–. (The current date is displayed on
		screen. The date you enter appears in its place.)