JVC HR-E439EG, HR-E239EG System, Access Mode Select, Confirm B.E.S.T. Status, Recording

16ENRECORDING(cont.)

	The B.E.S.T. (Biconditional Equalised Signal Tracking) system
B.E.S.T. Picture
	checks the condition of the tape in use during recording and
	recording and playback is “ON”.
	playback, and compensates to provide the highest-possible
System	recording and playback pictures. The default setting for both
	Recording
	1	LOAD A CASSETTE
Turn on the TV and select the VIDEO channel (or AV mode).
		Insert a cassette with the record safety tab intact.
		● The recorder power comes on automatically.

					ACCESS MODE SELECT
+		000	00000	2	SCREEN
	000	0	000		Press MODE. The O.S.D./
	000		0000
	000		0000
	000		0
–	000		000
	00		0
					B.E.S.T. screen appears.	: ON
					O.S.D.
					B.E.S.T.	: ON

RECORD	[MODE] : EXIT
	[5°] =[5]: ON/OFF

3	CONFIRM B.E.S.T. STATUS
	The default setting is “ON”. If this is the case, go to step
	4. If not, press PUSH JOG to place the pointer next to
	Þ
	“B.E.S.T.”, then press PUSH JOG%to set to “ON”.

	2
1	2	3
4	5	6
7	8	9
	0
	PLAY

RECORD

MODE

4

5

CLOSE MODE SELECT SCREEN

Press MODE.

START RECORDING

Press and hold RECORD and PLAY on the remote, or press RECORD on the recorder.

●The recorder spends approximately 7 seconds assessing the condition of the tape, then begins recording.

●When the "BEST" indicator begins blinking, that means adjustment is complete.

3

1

Display Panel Indication

PUSH JOG

As the tape check progresses, the “– –” marks on the display panel increase upward. Once the "BEST" indicator starts blinking, the check is complete.