Other Functions, If the Program Overlaps Another

– Timer Recordings –

IF THE PROGRAM OVERLAPS ANOTHER

NOTE: Do not overlap programs as portions of the conflicting programs will be lost. The first recording time has priority over the next recording time as shown in the diagram.

	8 : 00	9 : 00	10 : 00	11 : 00
Program 1
Program 2
		Deleted Parts
Program 3
		Non Recorded Portion Parts
Recording	Prog.1		Prog.2	Prog.3
Control Settings

NOTES: • The everyday/every week recording can be made continuously until the recording is canceled or the tape reaches the end.

•During timer recording, the automatic rewinding mechanism does not function.

Other Functions

Changing display information

Each time you press DISPLAY, the display panel shows the time counter and the clock time alternatively.

• When DISPLAY on the Remote is pressed, time counter will appear on the TV screen. To reset the time counter, press C. RESET on the Remote.

BLUE BACK — ON/OFF

When this function is set to “ON”, the TV screen becomes all blue in the following case:

When receiving a channel not in use.

1Press MENU on the remote. Press SET –/+ to select “SYSTEM SETUP”.

2Press SET –/+ to select “NO NOISE BACKGROUND”.

3Press ENTER to select “ON”.

4Press MENU to return to normal screen.

STEREO RECORDING AND PLAYBACK

RECORDING STEREO BROADCASTS

The VHS Hi-Fi audio system permits high fidelity recording of MTS STEREO TV broadcasts.

When a MTS STEREO broadcast is	STEREO
received, the STEREO will appear on the
screen for about 4 seconds and the
program can be viewed or recorded in
stereo.
The Hi-Fi STEREO recording procedure
is the same as for normal recordings.

NOTE: When using a CATV system, stereo TV programs may be transmitted over a mono cable channel. In this case the word "STEREO" will not appear and the sound will be in mono.

OUTPUT SELECTION

When viewing an MTS STEREO TV program, or playing a prerecorded VHS Hi-Fi STEREO videotape, press A.MONITOR to select how the audio will be heard through the speakers. Normally set to the Hi-Fi STEREO position, this button can be set to the MONO position if the stereo broadcast or videotape audio is of poor quality. The "R" and "L" positions allow the audio from the Right or Left Hi-Fi channel to be heard over both TV speakers. This button has no effect when viewing a MONO videotape or TV program. Each time when you press the button, OUTPUT SELECTION display appears on the screen for several seconds. Refer to the chart below.

OUTPUT	SOUND HEARD ON BOTH
SELECTION	SPEAKERS

STEREO	STEREO
L ch	LEFT CHANNEL AUDIO
R ch	RIGHT CHANNEL AUDIO
MONO	MONO

NOTES: • When playing back a tape that is not recorded in Hi-Fi stereo mode, the audio will automatically be monaural.

•When listening to a VHS Hi-Fi video tape or MTS broadcast through the VHF/UHF jack (Audio/ Video cord not connected), the sound will be monaural.