JVC HR-A230ES, HR-A231EK Select NEW Station, Switch Stations, Enter NEW Character

28

USINGTHECONFIRMATIONDISPLAY (cont.)

CH SET

2

1 2 3

4 5 6

7 8 9

0

Perform steps 1 and 2 on page 26 to access the Confirmation display before continuing.

Set Stations (A)

		1	SELECT ITEM
			Press PUSH JOG%Þ until the item you want is
q	6		displayed. Then press OK twice and the station’s name
			(or "– –") begins blinking.

2	SELECT NEW STATION
	Press PUSH JOG%Þ until the new station’s name you
	want to store begins blinking.
	Registered station names (☞ pg. 30) appear as you
	press PUSH JOG%Þ.

3	SWITCH STATIONS
	Press OK.
	● Repeat steps 1 through 3 as necessary.
	RETURN TO NORMAL
4	DISPLAY
	Press CH SET.

PUSH JOG

			Set Stations (B)
	3	OK	NOTE:
			First perform step 1 of the above procedure.
1

		SELECT STATION NAME
2		CHARACTER
		Press PUSH JOG%and the first letter of the station
		name (or "–") begins blinking.
3		ENTER NEW CHARACTER
		Press PUSH JOG%Þ to cycle through the characters
	*		]		%
		(A–Z, 0–9, –, , +,		(space)) and stop when the
		desired one is indicated, then press PUSH JOG				to
		enter. Enter the remaining characters the same way
		(maximum of 4).
		After entering all characters, press OK.
		● Repeat steps 1 through 3 as necessary.
	● If you make a mistake, press PUSH JOG%%until the
		incorrect character begins blinking. Then enter the
		correct character by pressing PUSH JOG%Þ.
		RETURN TO NORMAL
4		DISPLAY
		Press CH SET.