Topfield TF 7720 HSCI, TF 7710 HSCI manual 3 Conﬁguring Usals settings

Page 36

30 Service Search

you had better check the receiving quality of every trans- ponder and choose the best one at the Transponder (or Frequency) option. It will be helpful to your ﬁne tuning.

5.Finally set the Motor Control option to Store to save the tuned position when the receiving quality is best.

There are more motor control options for installers, but this guide does not describe them. If you are an installer, refer them to the manual about the STAB rotor.

4.1.3 Conﬁguring USALS settings

USALS (Universal Satellite Automatic Location System), also known as DiSEqC 1.3, calculates the positions of all available satellites from your location. Compared to DiSEqC 1.2, it is no longer required to manually search and store every satellite position. Just pointing to a known satellite position is enough. This position will act as a central point. The USALS will then calculate positions of visible satellites.

To use the USALS protocol, se- lect the Installation > USALS Setting menu. You should see a screen like the left ﬁgure.

At ﬁrst you have to set the Mo- torized DiSEqC 1.3 option to En- able.

To get every satellite position calculated, perform the following steps:

1.Choose your desired satellite at the Satellite Name op- tion.

Image 36

Contents TF 7710 Hsci TF 7720 Hsci Page Contents Preference Settings Iv ContentsIndex Page Features IntroductionControlling the digital receiver IntroductionFront panel Controlling the digital receiverRemote control Used to select a menu itemPage Introduction Setup Safety precautionsUnpacking Setup Power speciﬁcationsPhysical speciﬁcations Rear panel connections Rear panel connectionsConnecting up your digital receiver Connectors speciﬁcationsConnecting the antenna Connecting to your televisionConnecting up your digital receiver To use the Hdmi connector To use the component video connector Switching on for the ﬁrst time Connecting to your video cassette recorderInserting batteries in the remote control Powering on and checking picture Switching on for the ﬁrst timePreference Settings Language settingsPreference Settings Language settings Subtitle languageVideo and audio settings Colour modelVideo cassette recorder Video and audio settings Television aspect ratioHigh deﬁnition television Local time setting Audio modeLocal time setting Preference Settings Local time setting Time offset table City Parental control Adjusting the on-screen display Adjusting the on-screen displayService Search Searching broadcasting services1 Conﬁguring LNB settings Service SearchSearching broadcasting services Service Search 2 Conﬁguring DiSEqC 1.2 settings 3 Conﬁguring Usals settings Searching services Searching every service of a satellite Searching one service of a transponder Editing the transponder list Resetting to factory settings Resetting to installer settingsResetting to factory settings Service Search Volume control Daily UsageWatching television Daily Usage Watching television Favourite services list Favourite servicesViewing programme information Selecting audio tracks Selecting subtitle tracksViewing teletext Viewing electronic programme guide Viewing electronic programme guideMaking timer events Watching multifeed programmeMaking timer events Desired satelliteListing Services Editing the services listListing Services Editing the services list Editing the favourite list Editing the favourite list How to use on-screen keyboard Transferring receiver dataTurn on the source digital receiver Transferring receiver dataFirmware Update Firmware UpdateChecking the ﬁrmware information From a USB memory device From a USB memory deviceFrom your computer via RS-232 port From another digital receiver via RS-232 port From another digital receiver via RS-232 portOver the air You can get a new ﬁrmware over the airIndex Index Wide-screen television Page Page Correct disposal of this product