5)Once mounted, secure the two captive screws at the base of DR-DV5000 to the camcorder.
6)Re-attach the battery system to the rear of the DR-DV5000. Ensure to connect all power cables and utilize the supplied gasket between DR-DV5000 and the battery system.
7)Finally, connect a 6-pin to 4-pin FireWire cable from the 6-pin FireWire port on DR-
DV5000 marked “DV I/O” to the 4-pin FireWire port on the rear of the camcorder marked “DV”.
(Connection of the 6-pin to 4-pin FireWire cable may not be necessary on all JVC camcorders (such as the GY-DV5000U(A). Check with JVC for information on different models. A flexible wire clamp located on the DR-DV5000 base provides restrain for the cable).
Power Options
The DR-DV5000 shares power with the GY- DV5000 camcorder no matter which power source is used. The 4-pin power XLR on DR- DV5000, the 4-pin power XLR on GY- DV5000 or the battery system can power both DR-DV5000 and camcorder simultaneously.
INSERTING AND REMOVING FSHDD-1 FIREWIRE DRIVES
The best way to get to know the FireStore FSHDD-1 FireWire HDD is by studying the supplied manual. The manual provides detailed instructions and illustrations.
INSERTING THE HDD: Insert the drive into the slot on top of the DR-DV5000 unit. Ensure that the power switch on the bottom side of the drive is set to “On” before inserting. The drive will only insert one way and features a “key” on one side to prevent incorrect insertion. Press down on the drive
