User Manual | Harmony 720 |
|
|
Using Your Harmony Remote
This section provides you with information that will help you use your remote.
Recharging the Battery
Place your remote in the base station to charge. While the remote’s battery is charging:
•The display and its backlight, and the keypad backlight remain on.
•The battery level icon in the status bar flashes when the battery is still charging or will display a full battery level when charging is complete.
When the battery is low, the display will flash a message to remind you to charge the battery.
Using the Tilt Sensor
When you pick up the remote slightly tilted, the display will automatically turn on and the keypad light up.
Note: Whenever you pick up the remote from the base station, or replace it in the station, you will hear a beep.
Use the Harmony Remote Software to enable/disable these features.
Selecting an Activity
View the Activities you have added by pressing the Activities button. The display will then list the Activities you have added. Press the corresponding display button next to the Activity you want to start.
As a default, when you select an Activity, you will see a message on the remote’s display reminding you to keep the remote pointed at your entertainment system while the Activity starts. This helps ensure that all infrared (IR) signals are properly sent.
Use the Harmony Remote Software to turn on/off the “Starting Activity” message.
Version 1.1 | Page 4 |